Router on a Stick Overview and Configuration

Did you know that router on a stick is related to Inter-VLAN routing? 🤔
In this video, I explain this concept in less than 9 minutes. I provide a high-level overview of the router on a stick and then jump right into the CLI configuration 🤓
This video is part of my popular Tech Nuggets series. The goal of tech nuggets is to cut to the chase & explain tech concepts in the form of small nuggets that you can consume right before walking into a customer meeting or a job interview 🧳
Got feedback? I would love to hear your thoughts. Drop them in the comments section below 🚀
___________________________________________________
FOLLOW ME ON SOCIAL:
LinkedIn: / najqazi
Instagram: / naj.qazi
___________________________________________________
#najqazi#ccna#ccna200301

Пікірлер: 9

  • @elliejackson2010
    @elliejackson20102 жыл бұрын

    Excellent nugget on router on a stick. Love it🔥🔥🔥

  • @NajQazi

    @NajQazi

    2 жыл бұрын

    Appreciate it ✊

  • @ondrejsvorc8175
    @ondrejsvorc8175 Жыл бұрын

    Thanks for a clear explanation! I recommend sticking strictly to the network diagram next time, though. You were using GigabitEthernet ports in the commands all along, not FastEthernet ones. A beginner might find that confusing. Other than that, great content! :)

  • @NajQazi

    @NajQazi

    Жыл бұрын

    I totally get it. My apologies for any confusion. I was in the zone when recording this video and didn't want to go back and make any changes. However you do bring up a good point and I'll refrain from doing this in the future. Appreciate your feedback

  • @markangelomuyot7571
    @markangelomuyot7571 Жыл бұрын

    hello sir how do i connect the isp in router on stcik

  • @NajQazi

    @NajQazi

    Жыл бұрын

    Terminate the ISP circuit into the router and configure appropriate routing such as static or dynamic. Also if it's an Internet circuit make sure you have a FW connect to the WAN router. Hope this helps!

  • @mechman4
    @mechman4 Жыл бұрын

    do you not have to, on router end assign the switchport g0/0/0 as a trunk ?

  • @NajQazi

    @NajQazi

    Жыл бұрын

    You don't create a trunk on the router. On the router you simply create a sub interface for each VLAN and specify encapsulation dot1q, in addition to assigning an appropriate IP address per subnet. That's it. Hope this helps!

  • @mechman4

    @mechman4

    Жыл бұрын

    @@NajQazi thanks. Makes sense.