The factory match is what I'm looking for! Have you tried them? I think I'll have to to buy from OTR it sounds like! Thx for the quick reply

Great video. Do you know if you can buy the harness holder for the bus bar wiring seperately?

@ReviewAllTheThings

5 ай бұрын

TY, It is is, PN 5273032 imgur.com/a/fLM3lyk

Very detailed installation video, I appreciate it. It helps me understand what I'm getting into.... Keep up the good work. Have you been able to find a light bar that has a switch that fits the cutout for the xp1000 NSTR ULT?

@ReviewAllTheThings

2 жыл бұрын

Thank You Jim. Haven't found a light bar with a switch that fits but have not really looked now that I found L Style factory fit switches and L style adaptors for V style switches from OTR Switch Guys www.otrattw.net/

Do you know of a double bracket to mount 2 pods on each side ?

Just got a 2021 Ranger and plan to put on lights. Could you please clarify, I'm a little confused by the L and V style stuff.. Do you know what style the factory switches are? I might just do those to avoid adapters and a like look with the other switches. I saw the factory switches somewhere online and remember they were spendy. Thx great vid and helped me a bunch!

@ReviewAllTheThings

6 ай бұрын

You want to get L Style switches to match the factory polaris switches. You can get custom lighted switches from OTR Switch Guys. If you want a simple 2pin rocker switch you can get Carling Technologies switches on Amazon. OTR uses Carling Switches. www.otrattw.net/ Carling Technologies Rocker... www.amazon.com/dp/B0BJ4TQYBY?ref=ppx_pop_mob_ap_share

@ReviewAllTheThings

6 ай бұрын

Check out this video, I swap a Rough Country V Style for a custom OTR L Style. kzread.info/dash/bejne/o6Fr1JKsnrOuc6w.htmlsi=EfTuz5QQLGJEkDGn

My lights didn’t come with those brackets I had to install mine on the side something I didn’t like but had no choice wish I could’ve gotten some of the brackets

@ReviewAllTheThings

Жыл бұрын

They have good customer service. If your kit should have had them I'm sure they will make it right.

Why did you not use the Red wire on the bus connector? I t thought the red and black was pos and neg.

@ReviewAllTheThings

2 жыл бұрын

The bus bar has 3 terminals. Constant Battery Power. Accessory Power Only (key on Power, key off no power) and Ground. I only wanted the lights and the light up switch to work when the engine is running or key on so I used the accessory Power only terminal and ground. Hope this helps.