For me the springs under the charger contact on the docking station were weak. I bended both to make them harder to push down, since I did not see this error. How I found this? :D I wanted to measure the voltage of the docking station output, so I pushed the measuring pins under the springs and the problem did not occur for a week. So I concluded that it must have something to do with the springs, I bended them, since it's OK (while the error came up every day before).
@danijel1242 жыл бұрын
In this particular case I think its the fuse on the motherboard. The fuse trips so the roborock thinks it isnt charging and tries to reposition... I also had error 13 even after motherboard change but upon closer inspection one of the charging pads on the roborock desoldered and I had to solder it back in place and the vacuum was working perfectly again
@RobotMasters4 жыл бұрын
Sounds like a software glitch, you can try resetting the robot, there a little reset button underneath the lid. You can also try removing the battery which requires removing all the screws underneath the robot. Let the robot sit with the battery removed for 30 minutes and try again. If that doesn’t work it might be a logic board or battery issue.
@miko-ht7xy
4 жыл бұрын
Finally got the roborock fixed on warranty. Problem: motherboard... Happy to have it back in operation.
@RobotMasters
4 жыл бұрын
@@miko-ht7xy Sweet, glad they got your Roborock going again 🤔😁😁😁
Пікірлер: 5
For me the springs under the charger contact on the docking station were weak. I bended both to make them harder to push down, since I did not see this error. How I found this? :D I wanted to measure the voltage of the docking station output, so I pushed the measuring pins under the springs and the problem did not occur for a week. So I concluded that it must have something to do with the springs, I bended them, since it's OK (while the error came up every day before).
In this particular case I think its the fuse on the motherboard. The fuse trips so the roborock thinks it isnt charging and tries to reposition... I also had error 13 even after motherboard change but upon closer inspection one of the charging pads on the roborock desoldered and I had to solder it back in place and the vacuum was working perfectly again
Sounds like a software glitch, you can try resetting the robot, there a little reset button underneath the lid. You can also try removing the battery which requires removing all the screws underneath the robot. Let the robot sit with the battery removed for 30 minutes and try again. If that doesn’t work it might be a logic board or battery issue.
@miko-ht7xy
4 жыл бұрын
Finally got the roborock fixed on warranty. Problem: motherboard... Happy to have it back in operation.
@RobotMasters
4 жыл бұрын
@@miko-ht7xy Sweet, glad they got your Roborock going again 🤔😁😁😁