Nice job, thanks for explanation 👍🏻✌🏻

I went into this with no soldering experience. When I took the bad fuse off, there were two reddish rectangles underneath. Are those solder pads? I removed those too and there was a metallic material underneath the red rectangles. Was the new fuse supposed to be soldered to those red pads?

May I ask where did you get the replacement fuse in the US? Thanks!

Hi Everybody! I have Roborock S5, and the charging is not working, the vacuum cleaner always come off form the charger. How can i find out if the charger is the problem, or the battery or the vacuum cleaner mainboard? Thx in advance!

Dziękuję Robrock s55 śmiga teraz super :)

@TechDayEveryDay

Жыл бұрын

Proszę bardzo :)

In my S50, fixed the charging error by changing the main capacitor in the charger. 10 minute job.

This fixed the Error 13 on my Roborock E25, thanks!

@TechDayEveryDay

5 ай бұрын

You are welcome;)

Where do you get a fuzz like this? How Do I know if it applies to the s7?

Yessss it works. Thanks for sharing my roborock is back!

@TechDayEveryDay

7 ай бұрын

You are welcome

Moin, ich habe das selbe Problem wo kann ich so eine Sicherung bekommen? Gibts irgendwo auch einen Schaltplan?!

it works thanks !!!

Measured the resistor and it shows 0.15-0.4 values. Jumped it with a wire just to be sure....stil have the same error...any help? Battery ang charging station measures where ok. Also switched the battery Frome and with a friend's robot and his work fine with both of them, mine gets the error 13 with both ones

What is the liquid that you put on the bad fuse to take it out?

@iam5085

Жыл бұрын

Flux?

Hi, temp of the air flow?

What are you using there to get of the old fuse?

@TechDayEveryDay

Жыл бұрын

I'm using hot air.

@schr3ck3

Жыл бұрын

@@TechDayEveryDay with what device? And what is the liquid? And isn't there some danger because of the hot air and the parts close to the fuse which should not get broken?

@TechDayEveryDay

Жыл бұрын

@schr3ck3 please check link from below www.google.com/amp/s/www.instructables.com/SMD-SOLDERING-101-USING-HOT-PLATE-HOT-AIR-BLOWER-S/%3famp_page=true

I first changed the capacitor on the charging station but that doesn't do anything, and after that i did what you did which was quiet a hussle (used another brand of a resettable fuse) and it the robot is finally charging again

@TechDayEveryDay

10 күн бұрын

It is nice to hear that it helped you.

I changed the whole motherboard and that didn't solve my problem, so i changed the charging base and then yes that was definitely solved

Hi I also have a error 13 problem with my robot. But mine charges. Once the robot is charged and i try to start it it just turns off. Once it restarts it starts to charge again. I tried a known good battery but the problem still prevailed. I also jumped the fuse on the Mainboard but it did not held. What could I try now?

@samashraf4587

Жыл бұрын

i have the same problem. have u solved ur problem?

I have that!!!!

Unfortunately that didn't fix it. will keep looking!

My dad called it suckerbot 2000