Rlaarlo terminator 🎉❤😊

Thank you for uploading this how-to video! I was searching for just this type of info on the omni terminator.

So pretty much the two servo screws have to be unscrewed form underneath and the rest should be easy . I can’t believe I didn’t mesh correctly but I did and am replacing the pinion and spur gear . The spur don’t look so bad but I can tell by the sound it can be better . Now , instead of paper I like to mesh the pinion and spur by sound and slow throttle . I push it all the way in , turn on the transmitter and car , and carefully move the motor kinda like a pry with a screwdriver u til it sounds good . I tighten down and re check and it hasn’t failed me since . I forgot to tighten the screws the first time.

Someone needs or make some vids on the in’s and outs of this particular RC and especially the controller. Mine came locked and I haven’t fidgeted with it yet but I know holding the reverse whist turning on will lock and unlock when it’s set . I also noticed nobody Saudi anything about the new turbo function that gives a 30% boost to acceleration. Not a 30% boost above top speed but a 30% boost to get to top speed . It has its own two wires going to the receiver and esc . It’s in the manual near the back pages . Haven’t tried the gyro or anything . It came locked and set . Can’t even adjust the throttle or trims since it’s locked but they did set it perfect at Rlaarlo imho . I. Just wondering if it’s set to below top speed

Hi mate there's no sound to your video 😢

Bro,can u tell me how do you setup the diff oil？thanks!!