would love to see a sidevieuw of the setup , have a rf45 and im not sure if it would clear the base when mounted that way
@DavidR8
2 жыл бұрын
I’ll shoot some pics/video of that.
@watahyahknow
2 жыл бұрын
@@DavidR8 thank you
@woodywoods53737 ай бұрын
What brand did you use for the powerfeed?
@DavidR8
7 ай бұрын
I used a powerfeed from Vevor. Nothing special.
@woodywoods5373
7 ай бұрын
@@DavidR8 Ok thanks 😊
@freestyla1017 ай бұрын
Does it clear the base of the X axis when wound all the way from left to right?
@DavidR8
7 ай бұрын
Yes it did.
@freestyla101
7 ай бұрын
@@DavidR8 I didn’t think that style would due to the size
@DavidR8
7 ай бұрын
@@freestyla101it will depend on what mill you have. That mill, a Long Chang LC30 had a fair bit of distance between the table and the base casting.
@freestyla101
7 ай бұрын
@@DavidR8I have virtually the same machine. The top half of the table will actually travel over the bottom half leaving it exposed in either direction by a good 5” or so. This is why you see the other style of powerfeed that does not hang down - it doesn’t foul on the table. Its a shame I can’t see the side of your table where the hand wheel is
@DavidR8
7 ай бұрын
I have a bunch of photos I can send. Shoot me an email @freestyla101
Пікірлер: 16
would love to see a sidevieuw of the setup , have a rf45 and im not sure if it would clear the base when mounted that way
@DavidR8
2 жыл бұрын
I’ll shoot some pics/video of that.
@watahyahknow
2 жыл бұрын
@@DavidR8 thank you
What brand did you use for the powerfeed?
@DavidR8
7 ай бұрын
I used a powerfeed from Vevor. Nothing special.
@woodywoods5373
7 ай бұрын
@@DavidR8 Ok thanks 😊
Does it clear the base of the X axis when wound all the way from left to right?
@DavidR8
7 ай бұрын
Yes it did.
@freestyla101
7 ай бұрын
@@DavidR8 I didn’t think that style would due to the size
@DavidR8
7 ай бұрын
@@freestyla101it will depend on what mill you have. That mill, a Long Chang LC30 had a fair bit of distance between the table and the base casting.
@freestyla101
7 ай бұрын
@@DavidR8I have virtually the same machine. The top half of the table will actually travel over the bottom half leaving it exposed in either direction by a good 5” or so. This is why you see the other style of powerfeed that does not hang down - it doesn’t foul on the table. Its a shame I can’t see the side of your table where the hand wheel is
@DavidR8
7 ай бұрын
I have a bunch of photos I can send. Shoot me an email @freestyla101