Repair RC Plane Covering Film
In this episode, I cover the basics of rc plane covering repair.
Rips and tears to the covering are a common occurrence. Anything from tall grass to bumping into other objects, can damage the covering on your rc plane. This is one of those easy fixes that, gets you back in the air, quickly!
Tools needed:
**Note**
Links below are affiliate links to the tools. When you make a purchase, I may receive a small commission from the sale. Don't worry, it doesn't cost you any extra to use these links. :)
Sealing Iron: amzn.to/2QK3v27
Iron Sock: amzn.to/3vdr0j1
Xacto Knife: amzn.to/3uelefy
#11 Blades: amzn.to/3fJkIBj
Covering used: amzn.to/34aSQAG
Self Healing Mat: amzn.to/2ShNJvF
Straight Edge: amzn.to/3f8AgPL
Connect with me on Social Media
Facebook: / thetravelingtechguy
Twitter: / tavelingtech
Пікірлер: 8
Alternatively, use cotton baby socks on heat iron
@TheTravelingTechGuy
9 ай бұрын
I use those as well! Thanks for the comment and for watching!!!
Thanks for the video good info, I am somewhat new to RC Planes and have a question. I purchased a tower hobbies trainer Rc plane and have been working on putting together. I was just about finished when I realized the servo centered under the wing I did not put the brass and rubber grommets in the 4 holes. I tried to take the screws back out and ended up stripping the screws, then tried using a screw extractor when I applied pressure to the screws I snapped the wing in half and the small piece of wood that was glued in the center between wings. I then was going to make a new piece of wood to go in between by cutting in front of the old piece and re-glue it. I don’t think this will work and end up making more of a mess with the wing. The piece of wood originally had a slot cut to slide into both sides of wing, I’m not going to be able to do that with the new replacement wood. I never did monocote before so I’m thinking I should cut open the area where damage is glue wings back together with area open I can use clamps for a good fit. I hope I gave enough detail in what I’m doing what is your opinion on this project. Thank you
@TheTravelingTechGuy
4 жыл бұрын
Sorry, don't know how I didn't see you message until now?? I imagine you have already repaired or replaced the wing by now? Which way did you go? If you repaired it, how did that go and have you had any flights on your plane?
@marksexton9827
4 жыл бұрын
The Traveling Tech Guy I haven’t yet I run a Bush Hogging & Lawn Service it keeps me pretty busy so it hasn’t given me a chance to do the repair. But I have already started where I cut small box holes underneath the wings to where I can get clamps in there put a thicker piece of wood and just appoxy the crap out of it that should take care of it
@TheTravelingTechGuy
4 жыл бұрын
Good luck! Let me know how the maiden goes and how good it flies...
Click bait? You have to ask?
@TheTravelingTechGuy
2 ай бұрын
lol thanks for watching!