Removing and Refitting the ECU Unit from a Peugeot 307
How to remove and refit the ECU unit on a 2001 to 2008 Peugeot 307. This video just demonstrates how to physically remove and refit the unit. If a new ECU is being fitted, the vehicle will not start until the immobiliser ECU has been matched to the engine management ECU. This can only be performed using dedicated test equipment. You will need to have this carried out by a Peugeot dealer or suitably-equipped specialist. Thanks for watching. Please comment, like and subscribe !.
All of my uploaded material is protected under copyright law. None of my videos may be re-uploaded, reproduced or transmitted, in part or in full, in any form or by any means, without the written permission of the copyright holder.
© / screwsnutsandbolts 2022
Read important information below:
Disclaimer
Under no circumstances will Screwsnutsandbolts be responsible or liable in any way for any content, including but not limited to, any errors or omissions in the content, or for any loss or damage of any kind incurred as a result of any content communicated in this video, whether by Screwsnutsandbolts or a third party. In no event shall Screwsnutsandbolts be liable for any special, indirect or consequential damages or any damages whatsoever resulting from loss of use, data or profits arising out of or in connection with the availability, use or performance of any information communicated in this video. Due to factors beyond the control of Screwsnutsandbolts, it cannot guarantee against improper use or unauthorized modifications of this information. Screwsnutsandbolts assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Screwsnutsandbolts recommends safe practices when performing any do it yourself repairs and or with tools seen or implied in this video. Due to factors beyond the control of Screwsnutsandbolts, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Screwsnutsandbolts.
Пікірлер: 13
Thank you for showing this.👍
@screwsnutsandbolts
2 жыл бұрын
No problem 👍
Nicely explained .Thanks for sharing.
Where is installed the srs ECU Peugeot 307 HDI 2004? Thanks
Thank you for the video but will the car start will appreciate your help
Where is the location of the camshaft position sensor in the Peugeot 307 2008, TU5JP4 engine? Please if you know share the video or picture. Thanks
Thank you so much for the video but did you replace anything from computer box or just did the steps will appreciate your help May God bless you
@screwsnutsandbolts
Жыл бұрын
This was just about replacing the unit
Nice to know thanks probably similar on my partner 2.0 l
@screwsnutsandbolts
2 жыл бұрын
Thanks for watching !
which one is the ignition wire or RPM signal wire
@screwsnutsandbolts
8 ай бұрын
I don't know, sorry. You might have to search for that info or get it from the ECU manufacturer.
Go