Thanks for watching my video. If you found this or any of my other videos helpful, maybe you could consider supporting my channel by using the ‘Thanks’ button below each of my videos. Your support would be really appreciated, thank you ! 👍 Screwsnutsandbolts

Perfect, this is correct for Nissan Note/Verso 1.4 petrol as well, I believe. Really helpful video thanks. Couldn't find any information on this anywhere else, but followed your clear video and stripped everything down and cleaned the solenoid. Quite gummy, with a few particulates around the mesh. Car hasn't felt more spritely in age! Thanks again.

@screwsnutsandbolts

Жыл бұрын

You're welcome, thanks for watching !

Excellent live Video description.I wasn't aware that these engines were fitted with this.Shows the importance of regular oil changes to avoid the issues you've highlighted.Best Wishes M

@screwsnutsandbolts

2 жыл бұрын

Thank you!

Thanks a lot !!! I fixed my Micra K12 III 1.4l 2005 Thanks again

@screwsnutsandbolts

Жыл бұрын

You're welcome, thanks for watching !

Million dollars information for me thanks 👍

@screwsnutsandbolts

2 жыл бұрын

You're welcome, thanks for watching 👍

Thank you for sharing. Your engine looks superbly clean there. Even a non mechanical person can watch this video and learn something from it. Thank you for making it so simple.

@screwsnutsandbolts

5 ай бұрын

Thanks for watching !

Is this the same as P1110 INT/V TIM CONT B-1?

I would like to know the jods The vvti soneloid

I have the same car when I put water in the radiator. Do I have to remove the air from the radiator when filling it with distilled water or does it have no place to vent the air?

@screwsnutsandbolts

Жыл бұрын

Fill it slowly to allow any air to escape. The manual says to fill it at less than 2 liters per minute.

Thanks again for the video, I have removed and cleaned the solenoid and the code seems to have cleared. Just got a question relating to the hose removed at the start. On my daughters micra, at the end of the hose where it pushes into the engine side, this was secured with gaffer tape!! Should there be a gasket on the end of the pipe or something else as it just flops about without the tape? Thanks.

@screwsnutsandbolts

11 ай бұрын

Do you mean the plastic intake pipe that goes from the bumper to the air cleaner housing ?. The one on my Micra also had black insulating tape wrapped around it to make it a tighter fit. I think when new there would have been tabs on the end that locked into place when rotated 90 degrees, but they have probably worn off or broken off over time. I think it should be ok to use tape to seal it as long as it isn't blocking any air flow.

@alancollin1990

11 ай бұрын

Ok thanks yes exactly what I meant.

Hello. I have a check engine light, bought an ob2 reader and code is p1760, it says clutch soleniod problem. Is that what this is please? Thanks a million for the video's 🙏🏼 you make it look very easy and very clear instructions. The playlist will come in very handy 👌🏻

@screwsnutsandbolts

Жыл бұрын

No a clutch solenoid is a very different thing, I think it's part of an automatic transmission

@robertscarborough68

9 ай бұрын

Thanks for the reply and your amazingly informative video's. You have helped me no end of times. Very much appreciated 🙏🏼 👍🏼 👏🏼

hello , very informative videos. Can you make a video for injector cleaning for Nissan k12, from unmounted to mount.

@screwsnutsandbolts

3 ай бұрын

Thanks. I don't have the Micra any more, sorry

I have a 2013 Nissan Micra k13 1.2L. I have owned it from nearly new and it has had regular oil changes. I have an issue with bad pinking when the engine is cold, under acceleration below 3000rpm, and if the aircon gets turned on it is especially bad. Could this be related to a faulty vvt solenoid? The car is at 192,000kms (so long commute each day), it otherwise runs well. Thanks

@screwsnutsandbolts

Жыл бұрын

Pinking is more likely to be caused by poor ignition timing whereas the the vvt controls the valve timing so I don't think it's related. Have you renewed the spark plugs recently ?

@karlpointon7112

Жыл бұрын

@@screwsnutsandbolts I’ve tried changing them for genuine Nissan ones but didn’t improve, I’ve also just replaced this solenoid and no change either. Unsure what else to try?

Does the P0011 code need to be cleared /reset afterwards? Great video by the way.

@screwsnutsandbolts

Жыл бұрын

I think it clears itself once the issue has been fixed

Hi, for what reason was this removed and cleaned? My automatic transmission 2005 K12 sometimes stays in second gear as I’m driving it, I then have to switch off the engine and switch on again and the gearbox is fine, any idea what this can be? I’ve taken the car to 3 mechanics and they plugged in their computer to see what the problem is but no reading codes Can you please help me resolve this problem, thanks Ps; your videos is very explanatory

@screwsnutsandbolts

2 ай бұрын

I know very little about automatic transmissions so I can't help you there I'm afraid. This link might be of some use: www.toyotaofmanchesternh.com/automatic-transmission-problems-shifting-gears-manchester-nh/

it shows error p0011 on my nissan note 1.4 2006 visa se (Bank 1"A" Cam Position Timing System Performance. Was told to replace that valve. Already bought the replacement one, didn't know i could only clean it, and try. If it appears to be different - then I might just try to clean the old one. Was thinking should i just do that or there is some other actions needed - like changing something with the computer diagnostic.

@screwsnutsandbolts

4 ай бұрын

No I don't think you need to reprogram anything after replacing it. You just need to clear the fault code to turn off the engine warning light. If you don't, or can't, it will likely turn itself off after driving for a few kilometers, once the problem is fixed.

@bobacurt1321

4 ай бұрын

@@screwsnutsandbolts Thanks a lot for help!!

@screwsnutsandbolts

4 ай бұрын

You're welcome !

Can I get a Samaritan who can advise me ,nissan march cr12 ,when it drives its not speeding up some times it's noisy like inside of the engine, and while driving it stop onthe road upto now just cranking no starting, what is the problem please can someone help me on that problem

@tonylupu6878

Ай бұрын

I have the same prob, did you get that sorted?

Hi, i can see that next to the pcv valve you do not have the packing (14033ax600), when i cleaned the pcv valve i could see that that packing was flat and destroyed over time. Do you drive without it?

@screwsnutsandbolts

4 ай бұрын

Which part ?, where exactly in the video ?

@knuterikdegarden8067

4 ай бұрын

​@@screwsnutsandbolts 5:20, right next to the pcv valve.

@screwsnutsandbolts

4 ай бұрын

It could have been stuck to the underside of the airbox when I removed it. I don't have the K12 any more so I can't check. I would certainly replace it if it was damaged

I changed my spark plugs 2 days ago and i found cylinder number 4 the one next to the solenoid had oil in it to the top I tried removing the solenoid it wiggles around but it wont come off Does it have anything to do with the oil in the cylinder ?

@screwsnutsandbolts

3 ай бұрын

Do you mean oil in the spark plug tube ?. That could be a failed oil seal in the cam cover. I'm not sure about the solenoid, once you remove the bolt it should only be held in place by the rubber seal

@johnjai1489

3 ай бұрын

​@@screwsnutsandbolts is this the same as P1110 code?

@keemoak.

3 ай бұрын

@@screwsnutsandbolts yes the oil was in it the coil was full with oil too

How long would you recommend leaving it to dry before refitting

@screwsnutsandbolts

Жыл бұрын

Just a few minutes to let the cleaner evaporate and for it to warm up to the ambient temperature.

@KribensisUK

Жыл бұрын

@@screwsnutsandbolts can’t thank you enough for your videos. I’ve got the fault code p0011 coming up so I have tried this but I noticed one of the mesh parts is missing and stuck further up the solenoid. The car has typical symptoms of high/rough idling very juddery and cuts out sometime a when coming off the gas. Would you recommend changing the solenoid first or maybe start looking at injectors. Once again thank you

@screwsnutsandbolts

Жыл бұрын

From what I read code P0011 is usually associated with the VVT solenoid. Is the broken piece of mesh preventing the solenoid from fully opening and closing ?. I've seen that happen before

Hi i have problems in my Micra K12 only in morning it cause rough idling but when it warm dont have any check engine, i diagnose it and it say p1171

@screwsnutsandbolts

6 ай бұрын

That fault code indicates a vacuum leak, possibly between the throttle body and intake manifold

@endrittoli3464

5 ай бұрын

@@screwsnutsandbolts thnx very much but i have checked everything, vaccum tubes, change throttle body, map sensor, camshaft sensor, cleaned the injectors and make it again just in the morning jumping idle p1171, someone told me timming chain, i am really confused what to do please

@screwsnutsandbolts

5 ай бұрын

If you've done all that and still have the issue, I think you'll need to take it to a garage to have it diagnosed by a mechanic, just to be sure

@JayAceUK

5 ай бұрын

@@endrittoli3464 I’ve got exactly the same issue, checked and replaced everything! With the VVT solenoid unplugged the car runs lovely now but with engine light on (so not actually fixed).

Hello, where is the Micra K12 gasoline recycle valve located, thank you.

@screwsnutsandbolts

3 ай бұрын

Do you mean this one: kzread.info/dash/bejne/rHaLy5uDYdW9eKg.html

@MarioMario-gl2io

3 ай бұрын

@@screwsnutsandbolts no canister valve

What is the symtoms of a defective solenoid valve

@screwsnutsandbolts

Жыл бұрын

Common signs of a clogged or failing VVT valve include a rough engine idle, the check engine light coming on and the engine stumbling when climbing hills or under load.

@figueiredojoaofelipecasimi3380

6 ай бұрын

Merci, je vais le faire cette semaine. J ai exactement ces symptômes