Hey I know it's been a while since this video had been up but I have a question where did you buy that unique pry bar? What's it called?

@firsttimejimmy9791

Жыл бұрын

Harbor Freight Tie Rod Separator!

@firsttimejimmy9791

Жыл бұрын

FYI, it’s a good Tie Rod separator as well😆

Just Saying, I watched a few of these videos on removing the steering wheel on a Boat, That being said , A ten Year old could have removed mine.

I am running mine port side,so with the connections facing port side,which connection should the cable go in top or bottom? Second I can't get the small tubing to lock in?Thanks for any info!

@firsttimejimmy9791

3 жыл бұрын

Did you use the pin provided or an Awl? An Awl (straight) will give you more pressure. Once you feel the the key way move, it will slide right in. Port side is how I hooked it up first!

@firsttimejimmy9791

3 жыл бұрын

I’m almost positive it was bottom because that was the easier way to get it in.

@paullozis9731

3 жыл бұрын

@@firsttimejimmy9791 Does it matter, as long as the steering is correct,that turning the wheel the boat goes in the same direction?Thanks again

@firsttimejimmy9791

3 жыл бұрын

@@paullozis9731 The hole definitely matters! If you watch this video or one of the other two where I put it in the wrong hole, I turned left and the boat turned right. I fixed it by switching holes. But, if you are saying you put it in a hole and you turn the steering wheel left and the boat goes left; we’ll then you have it in the right hole.

@paullozis9731

3 жыл бұрын

@@firsttimejimmy9791 Thanks for the information! 👍

How did you remove the cable on the safe t?

@firsttimejimmy9791

3 жыл бұрын

There is a key that comes with the unit. It’s a circle with a pin that comes off of the circle. I think it’s called a Hitch Pin. Or you can take an Awl, and push in the designated hole and release the clamp from the steering cable end. The Awl gives you a lot more power to push in.