Kapag po ba propped beam at fully restrained beam, maximum moment is always negative?

Sir what if may given na condition. Say for example sinabi na net tensile strain €t >_ 0.005. Sa Steel Ratio Limitations, ano po ba magiging formula for Rho max? Yung may 3/8 (0.85) β (fc'/fy) po ba?

@EngrDeLaCruz

3 жыл бұрын

Yes. Actually any value of strain that is greater than 0.004 is acceptable as your limitation as a designer. But for exam purposes we usually use yung 0.005 to maintain tension controlled section.

Good day po sir! Ano po reference niyo dito sa topic natu sir?

SIR MERON PO BA TO TEMPLATE

Sir applicable parin ba ang rho balanced sa NSCP 2015?

@EngrDeLaCruz

3 жыл бұрын

Yes, rho balance is based only in strain compatibility. Disregarding what version of the code

@elixerjohngadingan4600

3 жыл бұрын

@@EngrDeLaCruz arigathank you sir💕

Hello po engineer. Paano po malalaman if anaylysis or design problem po ang problem? Salamat po

@honeygraceongayo922

4 ай бұрын

Same question po 😢

@philipamerjacobcinco4300

3 ай бұрын

@@honeygraceongayo922 Analysis po siya kapag ang hinahanap is ang Ultimate Moment (Mu) then Design naman kapag ang hinahanap ay ang Area of Steel (As). Usually pag design problems (hahanapin ang As), given na ang Mu, but this particular problem hindi binigay si Mu so need mo pa siya i compute using theory of strcutures, then pag may Mu kana, magsosolve ka for As.