Amazing, I was looking for a raw data for the 737, I found this for A320 but your covered many things to be used with any aircraft. Great explanation and you went to the point! Awesome! Same presentation about how to performing in a sim interview will be fantastic. Thank you

Very informative, helps a lot!

Awesome video. Thank you.

Excellent Presentation,Superb tips

@a320descentenergymanagemen3

Жыл бұрын

Thank you, glad you like it.

amazing captain

thanks for the tips cap

Thx: concise, comprehensive. I used X-PLane with pedals and flight multipanel and I would say its helpfull to mantain handflight (rowdata, visual) + operational skills. Additionaly, I can do things that usualy not allowed in company. That is an adventage.

@a.nelprober4971

Жыл бұрын

Xplane is king. Great for energy management.

Very helpful video

Thank you.

Thank you very much

Hello sir, thank you for the explanation, it is so helpful. I will be having an airline interview next month that I need to do a sim eval in an a320 sim, but the problem is i never flew a turbofan before, and i was told i need to perform a raw data ils approach with strong wind, what do you recommend me to do at this time. Would it be ok if i follow your way of flting in the video Thank you once again

@a320descentenergymanagemen3

2 ай бұрын

Get a high quality joystick and 2 engine throttle, then practice with X-plane and Toliss A321. Hire some time on a real Level-D sim if you can. The method I describe in this video I think is tge best way to do it. You might find that another method works better for you, but this is a good place to start.

Dear Captain thanks for the video. Can you explain the proper technique to fly a ILS with FD on? I’m having some issue in my LT in the last part of the approach and the flare technique. I’ve been told to follow FD until 50ft but I don’t now why lately I’ve experiencing late flare. Specifically, when the red chevron on PFD shows up and the FD indication moves fast and with large amplitude downwards. I’m presently flying A320 and A321. Could help? Kind regards🙏

@a320descentenergymanagemen3

Жыл бұрын

Flare technique is a controversial subject. Even instructors don't agree. But I'll tell you what I teach. Take the AP off from 1000 ft, provided you are visual. Follow the FD very accurately down to 100 ft. Every now and again look outside and note the position of the aiming point in the windscreen. Remember the average position. Then at 100 ft only look outside and keep the aiming point in the same position in the windscreen. Be assertive and notice the plane getting high or low and fix it. Never look inside below 100 ft. Do not look at the FD, GS, or VS below 100 ft. Only look outside. The flare height depends solely on the vertical speed. The touch down is affected by the VS, how high you flare, how long you flare (time), how much you flare (side stick deflection), and if you modify the side stick input during the flare. Also, always close the thrust at 30 ft, not earlier and not later. Be assertive. Use as much or little side stick input as required. Whatever it takes. Sometimes no flare is required if you have an updraft over the runway. You have to feel the force, like Luke. It all happens too fast to think about it. Get a feeling for it, like driving a car.

Hi, do we Arm the approach for ILS Raw Data in A320?

@a320descentenergymanagemen3

Жыл бұрын

No, because you have to switch both Flight Directors off, so there is no point in arming the approach. There is a small section in the presentation where I talk about the reason why both flight directors have to be switched off.

Maybe if possible you could help from the below? I'm at 140 knots following 354° inbound (CGS VOR). From my heading 354° to join 43°inbound RWY 04L at LFMN. I need a right turn of 49°. If I calculate my time for turning, would be speed/3° standard turn = 140knots/3=16.3 seconds. Then my bank angle is (140/10)+7= 21°. From these assumptions and the fact that I cannot turn before 5 NM from VOR, how do I know then when to turn? If I use the other formula IAS (approx to GS as close to RWY) squared / 10 , I get a radius of (140/60)2/10= 0.9 NM. But this assumes a standard bank angle of 25-30° right? Then in first assumption, my bank angle should be 21°. I'm confused there. If I use a third formula, 1% of GS, I get a radius of 0.7 NM (1.4/2) correct? Should I calculate the circumference of the circle and start turning from that circumference? It would be great if you could help me understand this!

@a320descentenergymanagemen3

Жыл бұрын

Hi, I replied at the VOR presentation video.

Hello, Tjeerd! I’d really like to purchase your book about descent energy management, but unfortunately I’m from a country which is not allowed on Amazon. Are there any other ways to buy that book? If necessary, I could pay in crypto.

@a320descentenergymanagemen3

8 ай бұрын

Which is that? You can only buy my book via the Amazon website, not via the Kindle app. Once you buy the book on the Amazon website and sync your Kindle app, my book will appear in your library.

Nice capt, vietnamese ??🎉

@a320descentenergymanagemen3

Жыл бұрын

Not Vietnamese, but in Vietnam.