Got a lot of requests to show disassembly of the fob. This is the easiest method I found do disassemble this style of fob.
Жүктеу.....
Пікірлер: 7
@easyhangit6047 ай бұрын
Byw. Easyhangit. Break the chrome off! Frig it. Once the chrome pices are off , it comes apart. All you need to worry about is hurting your computer board. Youre never goung to use the old case again. Dont waste your 45+ minutes saving your old fob! I just did it. Total time 7 minutes. Lock . Un lock. Auto start and panic work fine. No need for lock smith. The end!
@lyonanddebanderson4418 Жыл бұрын
I do comment; this was the best video of 100's that I searched that actually worked. Thank you, our video was the most helpful I found. KUDOS
@evantait74932 жыл бұрын
i rarely comment on anything but this is a terrible video the worst part is its not even correct
@easyhangit6047 ай бұрын
Take this off KZread. It's wrong in so many ways!!!!
@dennishester29132 жыл бұрын
Poor example of instruction to dis-assemble key fobs...use a tri-pod and work within the frame...do the whole process step by step and not assume the viewer understands.
@justanonymouse
2 жыл бұрын
I mean, I didn’t really have much trouble following along. It’s simple “pry here, push here”. If you need much more than that, take it to a dealer cause DIY isn’t for you.
Пікірлер: 7
Byw. Easyhangit. Break the chrome off! Frig it. Once the chrome pices are off , it comes apart. All you need to worry about is hurting your computer board. Youre never goung to use the old case again. Dont waste your 45+ minutes saving your old fob! I just did it. Total time 7 minutes. Lock . Un lock. Auto start and panic work fine. No need for lock smith. The end!
I do comment; this was the best video of 100's that I searched that actually worked. Thank you, our video was the most helpful I found. KUDOS
i rarely comment on anything but this is a terrible video the worst part is its not even correct
Take this off KZread. It's wrong in so many ways!!!!
Poor example of instruction to dis-assemble key fobs...use a tri-pod and work within the frame...do the whole process step by step and not assume the viewer understands.
@justanonymouse
2 жыл бұрын
I mean, I didn’t really have much trouble following along. It’s simple “pry here, push here”. If you need much more than that, take it to a dealer cause DIY isn’t for you.