What a nice nifty tool that is. Not seen it over in the UK yet Thanks, I will keep an eye out for it.
@hamzasaqlainfun4 ай бұрын
jongo power
@zumbazumba14 ай бұрын
I had a electric one i retuned it without grinding a single tooth on it -grinding wheel was wobbling -irony is they say in manual that you dont use machine if thats the case and that it should be returned to fix it . They actually made a flange that holds the wheel out of injected molded plastic -good luck getting it run true,it should have been made on a lathe while attached to a motors rotor to get true concentricty but that would be too expensive for cheap chinese brand . The hinges that have plastic with motor and grinding disc were made poorly it had play in it . Claw that limits chain travel had 2-3 mm play in it. Over all it was cheaply made with poor tolerances machine that will never do precise cut. I also returned the chainsaaw that i bough with it because chain sprocket was out of true so chain would jump out of bar.Horrible products.
@ErCanEverything
4 ай бұрын
There are very small gaps, but for now it is holding up well. I have the first version of the chainsaw and I am very satisfied, but as you say in the second version and I noticed that the chain is close to the pulley and throws it several times.
@tree-service4 ай бұрын
Why 4 times?
@zumbazumba1
4 ай бұрын
Because whole thing is flimsy ,fit and finish is crap and grinding wheel is out of center -it wobbles ?
@ErCanEverything
4 ай бұрын
Because I was cutting old wood with nails and hit nails a few times🫣😁
Пікірлер: 7
What a nice nifty tool that is. Not seen it over in the UK yet Thanks, I will keep an eye out for it.
jongo power
I had a electric one i retuned it without grinding a single tooth on it -grinding wheel was wobbling -irony is they say in manual that you dont use machine if thats the case and that it should be returned to fix it . They actually made a flange that holds the wheel out of injected molded plastic -good luck getting it run true,it should have been made on a lathe while attached to a motors rotor to get true concentricty but that would be too expensive for cheap chinese brand . The hinges that have plastic with motor and grinding disc were made poorly it had play in it . Claw that limits chain travel had 2-3 mm play in it. Over all it was cheaply made with poor tolerances machine that will never do precise cut. I also returned the chainsaaw that i bough with it because chain sprocket was out of true so chain would jump out of bar.Horrible products.
@ErCanEverything
4 ай бұрын
There are very small gaps, but for now it is holding up well. I have the first version of the chainsaw and I am very satisfied, but as you say in the second version and I noticed that the chain is close to the pulley and throws it several times.
Why 4 times?
@zumbazumba1
4 ай бұрын
Because whole thing is flimsy ,fit and finish is crap and grinding wheel is out of center -it wobbles ?
@ErCanEverything
4 ай бұрын
Because I was cutting old wood with nails and hit nails a few times🫣😁