My Turbo Tbird Finally hits the Track! Will it Blow Up?
Автокөліктер мен көлік құралдары
Today we finally hit the track again after all the upgrade over the last few months! Can we hit 12s (1/4 mile) before Street Car Takeover?
Remember to Subscribe and Bang that Like Button!
Social Media.
devinbauguess
/ chiefdbo
Пікірлер: 22
It made it through the night and back home again, I consider that a win
@ChiefDbo
Жыл бұрын
Always a relief to get home
Cams and adjustable cam gears will help with that powerband a lot especially on 2v’s
@ChiefDbo
Жыл бұрын
Gonna try to get the stock motor record for the 4.6l tbird. Will on my second engine
Probably should’ve foot braked one off the runs
@ChiefDbo
Жыл бұрын
Imma do that this week just to see. Only issue is that it builds no boost that way.
You made progress is what matters. It's slowly getting better. You need to pi head and intake swap it go from a low 300 to 400whp
@ChiefDbo
Жыл бұрын
I could get there with lower intake temps. Thinking about methonal injection
@jaceconder4584
Жыл бұрын
@Chief Dbo I agree that it would help but above all else those non PI heads are garbage with flow and you can get a PI intake anywhere minor flow improvements, also just as a FYI the throttle body off a 5.4l f150 is slightly bigger for flow on the outlet portion cheap junkyard mods. Anyway, I can't wait to see what's next. Keep it up, bud
@ChiefDbo
Жыл бұрын
@@jaceconder4584 npi heads are good for boost since they offer a lower compression ratio. Pi heads get most of their gain from the cam. i do agree the intake is way better.
@midnight347
Жыл бұрын
@@ChiefDbothe pi heads flow better and make more power the higher compression is a good thing and that is part of why you make more power but they also flow better. The 99 mustang was up 35 hp stock from the 98 and once modified there is a larger gap between them. The higher compression would be great with boost just run boostane to be safe if you can't run e85. I think it would make it alot faster a pi head and intake swap with aftermarket cams.
@ChiefDbo
Жыл бұрын
@@midnight347 the hp gain is mostly in the pi cam and intake. the pi head by it self only flows a little better. When ported they're almost the same.
What tire pressure are u running in the rear and what gears did u put in
@ChiefDbo
Жыл бұрын
20 psi. Didn't mess with air pressure all night
@readylucas
Жыл бұрын
@@ChiefDbo try 13-15 might not spin as much
You should do sick week
@ChiefDbo
Жыл бұрын
Might do some drag and drives in the future
Boosted, and struggling for 12's, must be NPI still. Thats gotta be frustrating 🤢
@ChiefDbo
9 ай бұрын
Yeah. Even got the original intake which is the worst one that came on the 4.6l😂
@joe735
9 ай бұрын
@@ChiefDbo yeah, that'll do it 🥴🤣. Damn trick flow intakes are stupid expensive, but I was gonna save for it, but I cant find a street burner in stock now. Guess I could deal with the little extra loss down low with track heat version. Its gonna have a 3500rpm stall anyhow.
Cams and adjustable cam gears will help with that powerband a lot especially on 2v’s