this is awesome man, thank you for sharing

Hi bro, thank you for sharing your design. I have a question: is that Flat Profile Keycap really necessary? Can I just use Actuation Plate alone to press switch?

@Someguy5k

2 жыл бұрын

If you check out the operational guide video, it shows that the flat keycaps in addition to the plates are in order to perform off center actuation.

@embetoon

2 жыл бұрын

@@Someguy5k Got it! Thank you, bro!

is using PLA fine for the motor? or will it run so hard that it warp the print

so what ajustments do i need to do to fit in long poll switches ??

Hey can i ask a question. That 30% infill will be enough ?

Hello, I wanna ask if the motor and the Female USB C to 2-pin 22 AWG Wires are soldered?

@mith2146

2 жыл бұрын

They are soldered by you after procuring both parts

What parts did you use to count the switch depresses? Was there a kit or do you have a bom?

@keyhubkb

2 жыл бұрын

I made a hotswap pcb to pair with one switch and track when it depresses with an ESP32 development board

@mith2146

2 жыл бұрын

@@keyhubkb that's the part that has me, did you design a single pcb and have it manufacturered locally or something? I've found some online that have 5x5 layouts that seem like you could "snap" one off but it also appears to possibly be traced together.

where did you get that motor?