Mustang Ford Tooling Lower Windshield Trim 1987-1993 Installation
Автокөліктер мен көлік құралдары
Bill shows you how to install this Pair of Ford Tooling Lower Windshield Trim on your 1987-1993 Mustang.
Product Link: www.cjponyparts.com/ford-tooli...
This pair of black plastic lower windshield trim moldings are made from Original Ford Tooling for a perfect fit and finish. If you're noticing some wear and tear on your lower windshield trim molding, these are a great replacement and installation only takes minutes.
To remove the lower windshield trim molding, you'll first the cowl and the outer pillar trim. Then, remove the thin weather stripping on the outer edge of the windshield in order to loosen the outer pillar trim. Use a panel removal tool to loosen the trim and then remove the original lower windshield molding. Make sure to also remove the original plastic clips and clean the area. Then, line up the Ford Tooling lower windshield trim molding and secure it in place.
Bill decides to remove the outer pillar trim all the way and a few coats of black trim aerosol paint in order to further refresh the look of our 1990 convertible. After he re-installs this piece, he re-attaches the weatherstripping to the pillar and secures the cowl back onto the hood. Total installation of just the trim molding takes half an hour, and takes about an hour if you wish to paint the trim.
Check out more Mustang Molding parts from CJ's here:
www.cjponyparts.com/mustang-mo...
Subscribe to CJ Pony Parts on KZread here:
kzread.info_c...
Пікірлер: 8
I'd like to add as well as when you have the cowl panel off, shine a light down and under on each side of cowl panel to see how much debris is down there. Using a shop vac and maybe even compressed air after all debris is removed will help clean this out. I'm sure if you've never done this, your going to be as surprised as I was the first time I did this.
Thanks for videos i keep restoring my stang just by watching you
Great vids! 👍 The CJ Vids are more comprehensive than the LMR ones.
Finally a proper tutorial, awesome video thx
On a Pinto there's a Philip screw holding the bottom trim on ea bottom corner, remove the side trim to get at them.
It would be nice if CJ - added the tools here and where to get them.
do you guys sell the trim for a 84 convertible ??
@andrewweaver12
Жыл бұрын
Ebay always has a lot of random parts for reasonable prices