Stefan, I just made the X6FG install a lot neater by carefully removing the outer shell of the X6FG receiver and installing it into the OE receiver box of my MJX 14210. What I did was drill a small hole where the X6FG antenna wire of the receiver has to come out in the front of the OE box and also drilled a small hole for the setting button, which I did not really need because I do not think I will ever run it without the gyro setting. I also ground off the small round protrusion inside the OE box and scraped out all the goo and tape that was holding the OE receiver in place to make the X6FG receiver board fit inside it. Please note that if you use silicone that it is electrically conductive while it is not set, so your receiver will not work if you put wet silicone sealant on it to make it waterproof, it will only work again after the silicone has set. I think my short video shows the final and neater reinstall of the X6FG receiver board and wiring.

Link

@stefan-norge

5 ай бұрын

Unfortunately I cannot link in youtube from aliexpress but you can find it easily in the shop „MB RC Store“ in aliexpress