Micca MB42 vs Edifier 1280t

Ғылым және технология

Edifier 1280T - amzn.to/2C3iih7
Micca MB42 - amzn.to/2CxtCBO
Music 'MGJ Dynamite' - • Best Non Copyrighted M...
Micca MB42 Specifications:
Woofer: 4″ Carbon Fiber Cone with Rubber Surround.
Tweeter: 0.75″ Silk Dome.
Enclosure: Ported.
Frequency Response: 60Hz-20kHz.
Impedance: 4-8 Ohms.
Sensitivity: 85dB 1W/1M.
Power Handling: 75 Watts (Each)
R1280T.
Total power output: 21W x 2.
SNR: ≥85dBA.
Input sensitivity: 750mV ± 50mV.
Distortion: ≤0.05%
Subwoofer / bass unit: 4 inch (106mm), 6Ω
Tweeter unit: Φ13mm silk domed tweeter, 4Ω
Frequency Response: 75Hz-18kHz.

Пікірлер: 35

  • @boblaws7582
    @boblaws75823 жыл бұрын

    Miccas have better midrange while the Edifiers sounded muddy, so my choice would be the budget friendly Miccas.

  • @lalitsingh4826

    @lalitsingh4826

    3 жыл бұрын

    But you will need an AMP.

  • @jungleking9703

    @jungleking9703

    2 жыл бұрын

    It's obvious because they have more wattage so they are farrer from their point of distortion than the edifier.

  • @imaflymydroneatit
    @imaflymydroneatit10 ай бұрын

    So I have a nice little Amp that I replaced and I don't want it to go to waste. I'm looking for some passive desktop speakers for work since I'm alone a lot at work and can listen to music. Three years later what would you suggest for passive speakers?

  • @jericoanacan76
    @jericoanacan763 жыл бұрын

    U can adjust the edifiers tone controls bit more to adjust the treble. That's why there are there for?

  • @manuelcaycedo561
    @manuelcaycedo5613 жыл бұрын

    awesome video brother thank you!

  • @sazzad_hossain.s

    @sazzad_hossain.s

    3 жыл бұрын

    Thanks bro!

  • @roninnovastar1321
    @roninnovastar13212 жыл бұрын

    Do you need an AMP to power these speakers ? or can plugging into a high powered reciever with old school wires do the trick ?

  • 3 жыл бұрын

    Micca has a powered bookshelf speaker now, PB42X to be exact, u should try those when u find a chance. Basically they are the same speakers as the MB42X with an amp.

  • @sazzad_hossain.s

    @sazzad_hossain.s

    3 жыл бұрын

    I have video on mb42 vs mb42x, check it out, since they are same speakers I didn't bother getting pb42x lol could be worth a try

  • 3 жыл бұрын

    @@sazzad_hossain.s they are, except powered ones have only 15 watts per channel max and the passive ones are 75 watts as u know. I wonder if that effects the sound quality, but in this video u hooked up the MB42s to an amp with 15 watts per channel too and they sounded pretty good actually. So maybe the powered ones should be good too, right?

  • @aijazamaankhan
    @aijazamaankhan4 жыл бұрын

    Hello I have Yamaha RX V683 AVR, I need a height speaker. Micca MB42 is good for this?

  • @sazzad_hossain.s

    @sazzad_hossain.s

    4 жыл бұрын

    So you mean surround speakers? Miccas will work great with that AVR, as long as you're ok with it's frequency range

  • @ankitpanchal9104
    @ankitpanchal91042 жыл бұрын

    Good job 👍

  • @SamInCanada
    @SamInCanada3 жыл бұрын

    I have the Micca MB42 speakers but they have little bass - I have to pair them with a sub. I am not sure where the big bass was from in the video. A hidden sub??

  • @sazzad_hossain.s

    @sazzad_hossain.s

    3 жыл бұрын

    Try adjusting the bass If you amp or receiver allow it, the bass isn't big like a subwoofer but it's adequate enough for close range, no hidden sub lol

  • @RogerYng

    @RogerYng

    2 жыл бұрын

    You don’t have the X version.

  • @lalrosangafanai6353
    @lalrosangafanai63532 жыл бұрын

    Suggest 2.1 channel amp

  • @jjjilani9634
    @jjjilani96342 жыл бұрын

    What about RB42? That is a better Micca.

  • @shahzaibihsan3259
    @shahzaibihsan32594 жыл бұрын

    the mic can't seem to handle the pressure, please add a low bass track to compare mids as well

  • @SleekBlack82
    @SleekBlack823 жыл бұрын

    Can you please tell me if the Micca MB42 work with a Fosi Audio TDA7498E Amplifier?

  • @sazzad_hossain.s

    @sazzad_hossain.s

    3 жыл бұрын

    Yep, will work just fine

  • @SleekBlack82

    @SleekBlack82

    3 жыл бұрын

    Okay, Thankyou so much for replying. Appreciate it :) I have another question though... Do these speakers accept standard 4mm Banana Plugs for the Amplifier connection?

  • @cmoneytheman
    @cmoneytheman Жыл бұрын

    Yesterday bought eds from bay for 70 upgrading from cr3s

  • @nickdad7136
    @nickdad71363 жыл бұрын

    is Micca suitable for Nad 320 BEE?

  • @sazzad_hossain.s

    @sazzad_hossain.s

    3 жыл бұрын

    Yes, it should be fine. Ohms and watts seems to be within compatibility

  • @nickdad7136

    @nickdad7136

    3 жыл бұрын

    @@sazzad_hossain.s thank you Sir

  • @one234569and10
    @one234569and105 ай бұрын

    Audio over YT is really not a great way to test the sound... HOWEVER, knowing that.. the Micca's sound way better, and the Edifires just sound muddy and meh. BTW - yes, I know this is a 3 year old video, but I am looking for something under 100 that I can use on my desk.

  • @maheshkarampuri6727
    @maheshkarampuri67273 жыл бұрын

    Song Name ?

  • @lalrosangafanai6353
    @lalrosangafanai63532 жыл бұрын

    Can you suggest a budget friendly amp for micca

  • @BOARDZofCANADA

    @BOARDZofCANADA

    10 ай бұрын

    No

  • @DarkvirusXI

    @DarkvirusXI

    8 ай бұрын

    iFi iDSD Black Label

  • @maheshkarampuri6727
    @maheshkarampuri67273 жыл бұрын

    Bro, Music name ?

  • @sazzad_hossain.s

    @sazzad_hossain.s

    3 жыл бұрын

    kzread.info/dash/bejne/naOZscSGeamomso.html&ab_channel=1261Clan

  • @yaabaa
    @yaabaa3 ай бұрын

    Hi. This is my useless comment for the day!!! I'm assuming Micca is pronounced "Mick-a" not "Mike-a" as it has two letter Cs in the name 😂😂

Келесі