Mercury 250pro Xs how to replace a waterpump start to finish!
Here is a video of me replacing a water pump in a 2019 250 pro Xs from start to finish and what I used hope guys enjoy and don’t forget to like and subscribe we are trying to grow this thing so we can bring you much better in depth videos on how to properly service your outboards! With over 20 years experience I want to share my knowledge with you guys and grow this channel again thanks for watching!
Part numbers I used
Impeller kit. 8M0142980
Housing 817275A1
Mercury high preformance gear lube
Tools
10mm Allen for the anode over prop
3/4 socket for the nut under the anode
3/4 wrench for nuts on the side holding lower unit on
Snap-on screw gun
10mm socket for water pump bolts
6mmx1.00 tan to clean threads and snap-on tap holder
Brakleen
Air blow nozzle
Permatex for a gasket use to be perfect seal they do not make any more
Water pump alignment pins 821571A1
2-4-C mercury grease
Пікірлер: 1
Great video, thank you! Can you elaborate on the 85 ft lbs on the "fat shaft" lowers? I have a 225 Pro XS with the For Torq SSR and it states 55 ft lbs. Do you also recommend replacing the Nylock lock nut every time, as there is no cotter pin, and it's the only thing holding the prop on, combined with the Belleville washer.