Gracias por compartir conocimientos.

@GentilsGarage

Жыл бұрын

De nada

you can just take to plastic cover off the right hand end and clean the carbon dust out a oil it up and then see if it is working all in one go without taking it out .simple enough

@GentilsGarage

2 жыл бұрын

Thats right for a more frequent cleaning but since this was the first time it was done on this car, I preferred to do it this way.

Thank you for the video. How do you manual activate this ERG valve to see if it still works?

@GentilsGarage

3 жыл бұрын

No idea. If it doesn’t work, it should through a code. Mine was just dirty,but not the worse I’ve seen.

Hello! Am having troubles with my own mercedes w211 with om646, loss of power and fault code 2359-1. I havent found any problem yet and will look into the egr, did you have any faultcodes?

@GentilsGarage

Ай бұрын

Hi, no fault codes as I caught it in time and cleaned it before it caused problems

how long did you leave engine running before remove valve ? Because I tried remove it with cold engine and it was impossible :-)

@GentilsGarage

3 жыл бұрын

David Grygárek at least 5 minutes. Yes, removing it from cold is impossible.

@ssdivizion

3 жыл бұрын

@@GentilsGarage It's not impossible,there is special tool for that like a giant sea crab tentacles

@GentilsGarage

3 жыл бұрын

@@ssdivizion I know, but 9 out of 10 of diy mechanics like me don’t have that.

Brother i have a w203 220cdi and i have same problem of egr , i watched some videos on KZread and i have done the same job that you also did.But after 2 week i have got the same problem that egr is not working any more and the engine light in on also. And when i have done diagnosis it show the error P0404 , P2062, P2014. Can you please help me!!!

@ihtishamarshad9033

3 жыл бұрын

What would you recommend me for this problem?

@GentilsGarage

3 жыл бұрын

Looks like your EGr is dead, so I would try and borrow a working one and install it. Reset the codes and see what happens. Looks like you have an issue either with the air flow meter or O2 sensors, so I would test them too with a multimeter.

@ihtishamarshad9033

3 жыл бұрын

@@GentilsGarage thank you so much brother, i have one more question 😅, my car show also that the the oil level sensor (in error) is not working, so i bought the new sensor and replaced perfectly, but it’s not working and I can’t check the oil level!!

@GentilsGarage

3 жыл бұрын

@@ihtishamarshad9033 no idea. Is it a proper sensor from Hella or something? My old BMW E46 had a non hella sensor and failed after a couple of months I installed it. Also, I made sure all contacts were clean. The code needs do be cleared after installing it. Apart from that, I don’t know anything else.

Do you pass ex. emision test with that car?

@GentilsGarage

2 жыл бұрын

Yes, no problem at all. Well below the limits.

U koferaunu gde se nalazi Senzor za rotaciju brzine i senzor za skretanje

@GentilsGarage

5 ай бұрын

thank you

That Red cap îs from The automatic transmission fluid.

@maximolevin5872

2 жыл бұрын

No, that is the engine oil dipstick tube. It does not have a dipstick. Auto transmisión disptick isnon the left.

Dajte prevod

How many kilometers was the car when you did this?

@GentilsGarage

6 ай бұрын

around 110,000Km

@mohamedanbi5013

Ай бұрын

Thanks for the response

there shouldnt be no smoke as the car is fitted with a dpf!

@GentilsGarage

4 ай бұрын

This has no dpf

@user-fi5cj4vi6i

4 ай бұрын

@@GentilsGaragehow can that be when my 2005 has one? yours is 2007

@GentilsGarage

4 ай бұрын

@@user-fi5cj4vi6i it wasn’t standard fitment until later. And I know it wasn’t removed because it doesn’t even come on the build sheet