I hadn't heard of Makercase. Can't wait to try it. thanks for the video
@johnsysum40552 жыл бұрын
Just saw this and apologize just realized you had done this...cheers
@TheWalter777 Жыл бұрын
👍👍👍👍👌👌
@henrydyck17012 жыл бұрын
Hey Anthony, after watching you do the math on the Y axis Zero, Here is a tip, to change the Y axis to Zero on the bottom left, in Inkscape go to Edit - Preferences - Interface and deselect the checkmark that says " Origin at upper left with y-axis pointing down (requires restart) Hope this helps
@brakthehun
2 жыл бұрын
Sweet!!
@tonecas2735
Жыл бұрын
Resizing the page for selection is easier way
@dalestone68562 жыл бұрын
If you append file and have to do 4 passes will it not also go over ur engraving 4 times? Thanks.
@brakthehun
2 жыл бұрын
I think you'll have to append with the same file 4 to esti do that. Ty it out.
@reneventresca35302 жыл бұрын
How did you get just the box into lasergrbl? It doesn't say where your images went?
@brakthehun
2 жыл бұрын
Downloads folder
@johnsysum40552 жыл бұрын
So how does Laser GRBL know to engrave and cut?
@michaelmitchell6898 Жыл бұрын
You did not explain how to handle kerf for a tighter fit.
Пікірлер: 13
I hadn't heard of Makercase. Can't wait to try it. thanks for the video
Just saw this and apologize just realized you had done this...cheers
👍👍👍👍👌👌
Hey Anthony, after watching you do the math on the Y axis Zero, Here is a tip, to change the Y axis to Zero on the bottom left, in Inkscape go to Edit - Preferences - Interface and deselect the checkmark that says " Origin at upper left with y-axis pointing down (requires restart) Hope this helps
@brakthehun
2 жыл бұрын
Sweet!!
@tonecas2735
Жыл бұрын
Resizing the page for selection is easier way
If you append file and have to do 4 passes will it not also go over ur engraving 4 times? Thanks.
@brakthehun
2 жыл бұрын
I think you'll have to append with the same file 4 to esti do that. Ty it out.
How did you get just the box into lasergrbl? It doesn't say where your images went?
@brakthehun
2 жыл бұрын
Downloads folder
So how does Laser GRBL know to engrave and cut?
You did not explain how to handle kerf for a tighter fit.
DuckDuckGo, yeah this guy likes his privacy...