KZread has not been notifying me of your videos, ypical technology people! Been there and done those bearings many a time. Top stuff young man!

@retro.restorations

3 жыл бұрын

Its been a bit funny lately I've had the same problem.

Cheers for this. Just started on Clangers rear axel. I had the same issues getting the drum off🙄

@retro.restorations

3 жыл бұрын

No worries . I came close to smashing them with bloody big hammer 🔨💪

Are you sure the springs go that way, on the pin I mean, instead of fitting into the shoes' holes?

@retro.restorations

2 жыл бұрын

Yeah on these single cylinder brakes It hooks on the pin. 🙂👍

Did the oil seal go back the correct way round?

@retro.restorations

2 жыл бұрын

I hope so! To be honest it was that long ago I can't remember doing it 😄👍

@harnserhoowt2824

2 жыл бұрын

Yep I know what you mean , I restored my 2a 30 years ago, and its been off the road for the last 15-20 years stored outside which was a big mistake, judging by the amount of rot in the bulkhead it looks like I will have to start again. I wonder what I will find that I got wrong first time round.

@retro.restorations

2 жыл бұрын

@@harnserhoowt2824 🤣🤣 potential nightmare then. Leaving cars stood outside is a recipe for disaster 🤦🏻‍♂️ best of luck. 🙂👍

It is really annoying that wheel cylinders don't come with new nuts. I'd pay extra just to avoid the pissing about.

@retro.restorations

2 жыл бұрын

Definitely! it would cost manufacturer's penny's to do but I'd bet they'd sell more. 🙂👍