Karcher BD 50/50 Floor Scrubber in Action!
Музыка
Bill Krokos of Hanson Industrial-Peoria, Inc. demonstrates a Karcher BD 50/50 Floor Scrubber in Action!
Hanson Industrial-Peoria, Inc. proudly represents LANDA, Mi-T-M, KARCHER, KEW, SIOUX, WATTS, KO Manufacturing and Hanson Industrial-Peoria, Inc. products!
Пікірлер: 55
Great demonstration. Thank you. Live in Denmark in Europe, far away but still this video made a difference :)
We got the machine at my job and I was looking for a video that explains all this because I want to keep it all clean and ready to go excellent explanation Thanks!
Excellent video! Thank you. Now I feel confident purchasing one of these units.
It was very helpful video. Now I know how to work the machine at work.👍
@jeromemoshe8653
3 жыл бұрын
instablaster...
Great job by the way
Excelent
I love this machine I use one at work, this was excellent thank you 😊👍 What height is best for the squeegee???
@billkrokoship
2 жыл бұрын
The best height is just dragging the floor should get you 95-99% water vacuumed. Have fun!
The effectiveness of the floor scrubber has everything to do with the clint's willingness to use the detergent solution! Spot cleaning might be more effective with a concentrated cleaner to dissolve accumulated grease and grime?
@billkrokoship
Жыл бұрын
Thanks for sharing!!
I was watching your video as you were cleaning it out? When you're done with the machine don't you have to take the pad off the machine, because if you don't the pad will form to the machine?
@billkrokoship
2 жыл бұрын
You can but if you raise the nose with the lever you won't smash the pad to the floor. Good question!
The one I use for work, only seems to clean in narrow lines but yours seems to be almost the width of the machine. Is there an adjustment that needs to be made?
@billkrokoship
5 ай бұрын
Yes, you can adjust the side brushes and the bottom brush. Seek help from where you purchased it from. They can do this as needed.
I would like to purchase this machine to clean my kitchen.
Why Leaking Compartment at right side next to pedal transport . Maintenance adjustment ?
@billkrokoship
2 жыл бұрын
Hmmm, not sure. Sounds like a solenoid may have debris in it.
WARNING!!! Flammable materials or reactive metals can cause explosion or fire. Don't use flammable materials or reactive metals in the tanks!!!
How do you change the pad?
@billkrokoship
Жыл бұрын
The lever on the right side just above the disc housing push it down. Then, back up the scrubber and the pad will be on the disc. Peel it off and install a new one. Wrap the pad around the center triangle. Reinsert pad under the disc housing, align with teeth and reinstall disc. Good luck!
do these machine clean tuff dirt such as gum, rubber marks, etc. ?
@billkrokoship
28 күн бұрын
@@spectator6656 The pads will do that but if too much gum is on the pad you’ll have to replace it. No issues with dirt etc.
Will This work on a textured floor?
@billkrokoship
Жыл бұрын
Yes
I own the same machine, but there is a problem that it does not drain water. Why?
@billkrokoship
Жыл бұрын
Something is blocking the water solenoid. Clean and flush and try again.
hey how much does this cost.is it good for commercial cleaning
@billkrokoship
3 жыл бұрын
Sells for $2995 plus shipping. Yes we have them in commercial applications.
How do u put on the scrub
@billkrokoship
3 жыл бұрын
Align it over the spline below and drop the right lift bar
How do u put on the Scrubber
@billkrokoship
3 жыл бұрын
Center it and lower head on down on the gears
Runtime on full charge?
@billkrokoship
7 ай бұрын
Up to 8 hours based on using AGM batteries and if fully charged.
The detergent has no time to do it's job this way. First wet the floor without hoovering. Wait a few minutes, so the chemicals can work. Then clean of with hoover on. After that you should neutralise the floor. Source: Kärcher dude.
@billkrokoship
2 жыл бұрын
That would really depend on the chemical being used and the temperature of the water. Also, the level of soil you are trying to remove. Good points!
How to do if the water not come out?
@billkrokoship
2 жыл бұрын
You may have a clogged solenoid screen. Lower Right hand side there is a rubber flap. Open the flap and unscrew the small grey cover and underneath is the screen. If you have a full tank use your water control valve to manage water volume when opened
@noeurnyanincambo810
2 жыл бұрын
@@billkrokoship thanks you 🥰🥰🥰
@billkrokoship
2 жыл бұрын
@@noeurnyanincambo810 You very welcome!
How to change the pad
@billkrokoship
5 ай бұрын
There are instructions in the manual. There is a level to drop them and reinstall.
It would be more ideal to have a drainage area to drain that
@billkrokoship
3 жыл бұрын
Yeah, could have taken it to our wash sink. It did give you the reality of what we sucked up.
Where is it made?
@billkrokoship
2 жыл бұрын
Germany
@cyranox90
2 жыл бұрын
@@billkrokoship Any chance it will be made in china? How to know if the clean water is full in the tank?
@billkrokoship
2 жыл бұрын
@@cyranox90 well...many things are made in China. Who knows for sure. Open the yellow cover on the front like in the video. There is a full line ...the flat area.
i have same this machain but can not drin watar
@billkrokoship
5 ай бұрын
See if it is plugged.
@3gasman
2 ай бұрын
Any factory warranty on this purchased new? Debating between this and a T5
Drain the dirty tank first.
@billkrokoship
24 күн бұрын
Although that is good to...we were making a video.....we don't have a slop sink.😢