John Deere 330 | Part 2
Автокөліктер мен көлік құралдары
1986 John Deere 330.Fixing the oil pressure switch, sharpening the blades, changing the hydraulic filter, adjusting the accelerator linkage, changing the air filter, and doing a short test.
1986 John Deere 330.Fixing the oil pressure switch, sharpening the blades, changing the hydraulic filter, adjusting the accelerator linkage, changing the air filter, and doing a short test.
Пікірлер: 13
Bill here from Ontario Canada I’d like to thank you for the link for the wiring diagram and all . Thanks from Bill in Ontario. I managed to figure out my mower deck installation Thanks again
I enjoyed watching it. Thank you
Check the pins on the hydro linkage fof slop. Theres one by the control lever that was worn out and it made it next to impossible to get the creep out of it
Hello bill,just replaced the 2 hydraulic hoses above the belly pan and now no leaks,but my deck will not move up or down,any clues Thank you
@tightwadproductions961
Жыл бұрын
If the only thing changed was the hoses, I'd think maybe there is air in the system. I can't see how just changing hoses could have any other impact.
Lame question, but what size socket did you use to remove the oil pressure switch? I’m leaking oil pretty bad there and the head of it looks odd.
@tightwadproductions961
Жыл бұрын
Apologies, but I do not recall the size and I have the mower loaned out at the moment.
Hello Bill her Ont Canada how did you correct your oil light on I have the same problem now? Now it’s very hard to start! Have oil in it pulled valve cover getting oil up top still hard to start! Any help would help THANKS Bill
@tightwadproductions961
Жыл бұрын
Check and see if your sensor is stuck closed. Sounds like it may be pulling to ground through the block and causing the light to stay on even when the engine is running.
Hello Bill here from Ont. Canada have the same tractor 330 anyway my problem is the lift arms how to hock them up O just looking at the video your hookup is different then mine? I ges I will have to figure it out on my own. Also could I get a copy of the wiring diagram if you don’t mind ?? Thanks Bill Ont Canada
@tightwadproductions961
2 жыл бұрын
Hi Bill, here is a link for the wiring diagram. www.wfmfiles.com/download/manuals/TM1591.pdf
@mrbowfam
Жыл бұрын
Hello William here how would I go about checking the sensor stuck closed ?? Thanks William
Sounds like shes due for new glow plugs too?