No video

Is this CHEAP REEL MOWER SHARPENER Worth It? Will it work?

So I found this cheap reel mower sharpener on Amazon, And when I mean cheap, it was only about 18 bucks for my 16 inch reel. Sometimes I find these things and I just have to try them out to see if they're any good. (Bosmere R345 Reel Mower Blade Sharpener, 16 Inch, Silver)I read through the comments and the reviews of the sharpener and honestly they're not very good. I would say that the 3.5 stars or whatever it has is pretty accurate.
Here are the few things I would say about it, this is not meant for high and reels. It will work very well for cheaper cylinder mowers and I could see this being a very useful tool for that. Aside from that, it didn't really attach well to my Hudson Star, I used up all of the adhesive strips that came with it in one sharpening, and I'm not exactly sure how long it will take to replace those strips.
Well the idea isn't necessarily a bad one, I would say that if you were spending money on a nice reel mower, find somebody who can sharpen it near you and really take care of that thing.
amzn.to/3LkIqBA

Пікірлер: 41

  • @rbruce63
    @rbruce632 жыл бұрын

    Outstanding! Just bought one for my Scotty’s 16!

  • @JStarke240
    @JStarke2402 жыл бұрын

    I used this on my SunJoe 24v reel mower as well. Gotta say, it worked remarkably well. I cleaned the base with alcohol prior to sticking the adhesive strip on, which I only lift a bit of the backer off and put in place and slide the rest off as I press it into place, and stepped the reel down very gradually between sharpening runs. Only making light contact with the abrasive. Definitely easier with a reel that spins on its own power, but it was shiny and sharp as ever, and only barely showed wear on the sand paper, just a bit of powdered steel left behind. Not to mention, it really seemed to get the reel into round, where one of the blades was a bit deeper/taller than the rest on the SunJoe, probably on purpose. Not only was the reel very sharp, it seemed to really get rid of a lot of/nearly all of the washboarding when cutting. This is likely due to getting the reel evened out and SHARP. I also bought two so I could use the extra mounting clips to ensure it was tight against the whole of the bedknife. I suppose it might be better to get it professionally sharpened, but I'm sure the folks that can sharpen a reel would laugh at the cost of the sharpening nearly equaling the entire mower with battery etc... Not the case with the Hudson, but most places charge a hefty fee for sharpening these things. Gotta say, these cheap tool videos are very good, and gives folks a good look at something before buying it. 👍 Thank you for what you do to help us out!

  • @perjian1697

    @perjian1697

    6 күн бұрын

    @@JStarke240 agreed

  • @Striperman
    @Striperman2 жыл бұрын

    I actually use 220 Grit sandpaper on my Allett before each use. Only takes a few minutes and keeps the blades clean and sharp. After each use hose down the blades and then use leaf blower to dry it off. Then apply a light spray of WD 40 silicone Blade stayed sharp

  • @Lawncology

    @Lawncology

    2 жыл бұрын

    Those are some great tips buddy

  • @themoistgreenorganic

    @themoistgreenorganic

    2 жыл бұрын

    Striper, I’m thinking I’ll try one of those sandpaper sponges 🧽 for painting. That way I can have a flat surface to lightly sharpen each blade. I use a Greenworks manual and have no idea on how to sharpen it.

  • @Striperman

    @Striperman

    2 жыл бұрын

    @@themoistgreenorganic I have actually used that sponge as well but it just wasn't gritty enough. Amazon sells back lapping kits for manual reel mowers.

  • @HClightdude
    @HClightdude2 жыл бұрын

    Totally have that for my sunjoe reel mower. I saw some review saying the adhesive wasn’t good. I let the sandpaper sit over night and I had 3 or 4 spring clamps on it. Works great. Now thinking about using it on a my 20” mclane since no one around me sharpens these mowers.

  • @lawnguy

    @lawnguy

    2 жыл бұрын

    I was totally going to forward this video to you in that sub thread from last week; when we were discussing the mclane and nobody in our area sharpening them

  • @landjml
    @landjml2 жыл бұрын

    A bit scary way to loose a finger 😳 I could see after some good adjustments it will do just fine. Thanks for showing alternatives ways to this process 👍🏽

  • @Lawncology

    @Lawncology

    2 жыл бұрын

    Yes indeed

  • @ayy1n
    @ayy1n2 жыл бұрын

    Good afternoon everyone

  • @ColeSpolaric
    @ColeSpolaric2 жыл бұрын

    I've often wondered if there were any at home diy sharpening kits that worked. And the answer I get from this is..... kind of

  • @Lawncology

    @Lawncology

    2 жыл бұрын

    That’s the best way to put it

  • @jontaylor4511
    @jontaylor4511 Жыл бұрын

    seems expensive for whst it is, i might try make one by mounting some abrasive stuff on a scrap of wood. it seems to have a curve to it, the curved dowel might work. or i'll just go over the blades with a sharpening stone or file.

  • @lawnguy
    @lawnguy2 жыл бұрын

    I really want to get into reel mowing on my yard. Mainly the front yard. Both front and back is 80% KBG 20% PR.

  • @HClightdude

    @HClightdude

    2 жыл бұрын

    I really wanted to reel mower to. Found a corded sunjoe reel mower for $80 on marketplace. However there are no aftermarket blades and bedknifes, even through the manufacturer. Then found a mclane with only “40hrs” on the engine for $300. I also snagged it up, 6 weeks later the gas mix with the oil and now engine is shot. Bought a “broken” ryobi cordless mower and gonna try to covert the mclane to eletric. Be careful reel mow can be addicting.

  • @lawnguy

    @lawnguy

    2 жыл бұрын

    @@HClightdude I was looking at the mclane 25. But seems like there’s bugs in them that need to be worked out. I may just bite the bullet and spend a little extra on a nicer machine.

  • @HClightdude

    @HClightdude

    2 жыл бұрын

    @@lawnguy yeah same here. There was a toro Greensmaster with a 10 blade for $800 on marketplace. Should of gotten that one.

  • @lawnguy

    @lawnguy

    2 жыл бұрын

    @@HClightdude Jimmy Lewis was selling his John Deere on there for $1800 I believe

  • @mynameisneb
    @mynameisneb2 жыл бұрын

    Cheap and Reel don't go in the same sentence, unless it's not a powered reel mower

  • @Lawncology

    @Lawncology

    2 жыл бұрын

    Bingo

  • @PacificNorthwestLawns
    @PacificNorthwestLawns2 жыл бұрын

    Remember what happened last time you randomly bought stuff in Amazon? 🤣🤣

  • @Lawncology

    @Lawncology

    2 жыл бұрын

    #hover

  • @ColeSpolaric

    @ColeSpolaric

    2 жыл бұрын

    At least he didn't accidentally buy 2 😂

  • @trevormuggeridge4560
    @trevormuggeridge45602 жыл бұрын

    First Aussie 😁

  • @mtb7018
    @mtb70182 жыл бұрын

    JP, is Greenphite not available for the DIY anymore?

  • @Lawncology

    @Lawncology

    2 жыл бұрын

    This year we couldn’t be guaranteed one of the primary components so we had to remove it from the roster. However, a new sheriff in town called GreeneKick will be on the scene as a high K replacement very soin

  • @mtb7018

    @mtb7018

    2 жыл бұрын

    @@Lawncology thanks 👊

  • @vicmills7702
    @vicmills77022 ай бұрын

    You use this first, then you back lab the opposite way to get a sharp cut.

  • @fadetoblack51
    @fadetoblack512 жыл бұрын

    I fail to see how this is easier or cheaper than lapping compound and a paintbrush.

  • @Lawncology

    @Lawncology

    2 жыл бұрын

    This would be something different than lapping. It fits into the “grinding” category for when blades have Dulled beyond backslapping and you don’t want to cut further into your bed knife

  • @andy-the-gardener

    @andy-the-gardener

    Жыл бұрын

    backlapping does not sharpen blades, apparently, from what ive read it cannot repair a rounded off edge (although i think it must, to a degree, if its done long enough). this kit is a cheap n cheerful version of actual grinding the reel to create a sharper edge profile. no reason it wouldn't work as in principle its what the pros do, ie rotating the cylinder forwards? against a parallel abrasive surface. its a good idea, but a bit pricey

  • @golddigger9326
    @golddigger93262 жыл бұрын

    That kit is designed to be used on the brill razorcut 38 reel mower only , helps to read the product info 😂😂😂😂👍

  • @Lawncology

    @Lawncology

    2 жыл бұрын

    The product info guide lists Many reel mowers For fitness and also provides. Accessories for certain other reel mowers. It is most definitely not meant for one

  • @JIMMYJREVIEWS_thaiM-A-F-I-A
    @JIMMYJREVIEWS_thaiM-A-F-I-A Жыл бұрын

    A Hudson Starr 2500 hundred dollar reel mower is not cheap my friend 😬

  • @ladytube64
    @ladytube64 Жыл бұрын

    I must say your viedo doesn't show the steps to use the sharperner...

  • @Lawncology

    @Lawncology

    Жыл бұрын

    Clip it on and spin

  • @golddigger9326
    @golddigger93262 жыл бұрын

    For crying out loud people your cutting grass not hair or shaving how sharp do you need it 😂😂😂😂😂👍

  • @Lawncology

    @Lawncology

    2 жыл бұрын

    😂😂 when it’s less than 1/10” sharper is better

  • @golddigger9326

    @golddigger9326

    2 жыл бұрын

    I agree