Thank you. Searched for 30min trying to find ANY videos on passive speakers much less how to setup properly. Thanks again. Only complaint, with my ADD mind there were few times I drifted away. [no offense but I felt like I was back in high school 20+yrs ago, listening to boring history stuff but had to fight my ADD and keep focus cuz if I don’t I’ll fail the class and have to repeat the grade all over again. 😂] ( maybe throw some jokes in smile a bit in your voice. Seem a bit happier) but other then that 1 small constructive criticisms, it was very helpful. THANK YOU👍🏻👍🏻👍🏻👍🏻🤡😉🙃😁

Best video to bridgemode on KZread

peave cs1000 to cs800 amp connection

Pardon me, But i am a bit confused. Base on analogy regarding Bridge set up, While ch A push, ch B is pulling, hence thee will be no sound coming out of speaker? They are not augmenting each other but rather cancelling out. pls enlightened me.

You’re connections ended with only 1 speaker utilizing the channel. So what do i do with other speakers?-Bridge Mode

how does NL4 speakon cable wired into bridge mode?

Hi I watch your video however it didn't cover my issue. I'm trying to figure out whether to use one RCA input to the bridged car amplifier or with a y adapter used both left and right. the manual has the speaker wiring as left positive and right negative for positive and negative speaker connections respectively. The owners manual does not state whether to use one or both with a y adapter. What do you think sir? I have another brand amp from the same year that states in the manual specifically to use the left only, the speaker wiring in the bridged mode is the same as the one listed above and also has a switch for bridged or stereo mode, not that that makes any difference. Thank you

Hi! Maybe I'm late here. We have an amplifier at our church, the owner's manual indicates that It delivers 2,300w at 4ohm in Bridge Mode. Can I use this mode to Connect two linked speakers of 1,800w and 8ohms each? Thanks and God bless you all!

Bruno, could you please make a video about amplifier's sensivity? There is barely nothing to find about in the www...

Hello so you say bridging the amp allows you to connect to one large speaker, but what if you want to connect to two speakers , How then? One more question I have a pair of Westlake 10" studio monitors spearkers , if a amp doesn't have enough power to push them would they sound like they are baffling with a lot of (highs) with not enough Bass? Because I have heard these name brand speakers ( 8" ) plays, the Bass sound coming from them were (Round) and powerful.

Not only is this series just about the only correct info on YT, the presenter is the most coherent in his delivery.

If people shared resources and knowledge like this guy we would have a cure for cancer and the world would be at peace. God bless this guy

The way you explain and the speed of speech are perfect for me.... The best I've seen in my whole life.... I have no words to describe....

i call this "teaching by heart' simple & clear.

i really love your very clear explanation sir. my power amp just arrived so i checked your channel about bridge mono connection and once more i learn a lot thaks you sir God bless.

THE BEST EXPLANATION

I was so happy that you included the "old" method, have been so hard finding out how to probably wire my speakers in bridge mode :)

thank you. greatfully without question. you explained it professionally and ultimately better then my professor did

Thank you for your information and the patience with which you shared it. Invaluable for those of us who are still learning about all of this.

This was by FAR the BEST explanation of ANYTHING I have ever seen. No joke. 100% Flawless