How to Replace Window Regulator 2005-14 Ford Mustang
Автокөліктер мен көлік құралдары
Buy Now!
New Window Regulator from 1AAuto.com 1aau.to/ia/1AWRG01968
Most power window problems can be traced back to either the regulator or the motor that drives it. TRQ produces affordable window regulators and motors that are designed specifically to fit your vehicle! This video shows you how to replace both the window regulator and the motor on your 2005-16 Ford Mustang.
• Buy TRQ at 1AAuto.com: www.1aauto.com/yt/i/1AWRG01968
• Check here for more videos on the 2005-14 Ford Mustang: • Ford Mustang 2006-14 5...
This process should be similar on the following vehicles:
2005 Ford Mustang
2006 Ford Mustang
2007 Ford Mustang
2008 Ford Mustang
2009 Ford Mustang
2010 Ford Mustang
2011 Ford Mustang
2012 Ford Mustang
2013 Ford Mustang
2014 Ford Mustang
Tools you will need:
• Phillips Head Screwdriver 1aau.to/oasf/1AXAA00013
• Pocket Screwdriver
• 10mm Socket 1aau.to/o4G/1AXAA00017
• 7mm Socket 1aau.to/o4G/1AXAA00017
• Trim Tool Set 1aau.to/oCo/1AXXX00006
• Needle nose pliers 1aau.to/ooz/1AXAA00051
• Needle nose pliers 1aau.to/ooz/1AXAA00052
• T30 Bit 1aau.to/otR/1AXAA00008
• Ratchet 1aau.to/oaua/1AXAA00016
• Socket Driver
• Socket Extensions 1aau.to/oacB/1AXAA00015
• Painter's Tape
• Pick 1aau.to/ojc/1AXAA00037
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
Пікірлер: 43
√ *Watch the Video* √ *Buy The Part at 1A Auto* 1aau.to/m/Shop-TRQ-Parts √ *Do it Yourself* √ *Save Money*
The best video on the subject, and the only one, for 13' Mustang
I followed this video with a third party regulator. Had a huge gap along the right side and corner. Spent hours adjusting everything with no progress. Installed an OEM Motorcraft regulator and everything aligned perfect first try. The clamp for the glass has a very different design. I highly recommend buying OEM and saving yourself the headache.
@Sosa_Baeby
Жыл бұрын
Hey do you have the link to the part that you bought? I’m having that same problem
GREAT VIDEO! STEP BY STEP AND STRAIGHT TO THE POINT!
Thank you for this, was kind of nervous about doing this myself but you're tutorial was spot on! Keep up the awesome work!
@TRQ
2 жыл бұрын
+Alberto Cruz Thanks for watching our video! 1aau.to/m/Shop-TRQ
Great informative video, took me about two hours total to complete this job!
Excellent Video- saved me about $500 from the local garage quote. The only thing I would say is, don’t stress on the adjustment screws and getting the window all the way up, because when the door of the mustangs closes, they go up an additional 1/4 inch or so on their own, to the top. Not sure why, but that’s what happens on mine. Great video.
You’ve been a huge help thank you
Thanks saved me a lot of time and money
Thanks for this video. Helped us fix my dads Mustang
Can you confirm that this is the same regulator used in the 2015 -2016 Mustang S550? The video was excellent . Best one on KZread yet. Thank you. -v-
Well this helped me a lot thank you sir
Very well done video. The exact steps that where for my 2014 Mustang. My mounting bracket for the T-30 bolt on the top with the door handle dangled down. So i had to pot that screw clip back in place and all is good. One thing. My window does not leave the gap with the door open with window rolled up and the roll up 1/8” after the door is closed like it use to. Not sure if that is just an adjustment or not.
Great video! Step by step perfection.
@TRQ
3 жыл бұрын
+Blackfire - WorldOfTanks Thank you! We love empowering our customers and showing how to perform DIY auto repairs with our high-quality auto parts. 1aau.to/m/Shop-TRQ
Very helpful
Thank you sir
My drivers side window is not as tight as the passenger side. If I shake the door by holding the glass, there is some play in the window. Whereas the Passenger side is solid. Also noticed the affected window seems to not curve into the car as much. Are there some ramps or plastic clips in the door assembly that need to be replaced?? Window goes up high enough and tucks under weather stripping but I would have a better seal if it would curl in when putting the window up. Any ideas what to look for and adjust?
Besides the up and down adjustment, shouldn't it have also been adjusted a little back towards the rear so that it gets a better seal abutting against the plastic molding?
Have a 2014 mustang with a driver side window issue. Window is stuck in the closed position. Fuse is good. When I depress switch I can hear a slight click from inside the door panel so I'm assuming the switch is good. Is this most likely the motor?
Thanks helped me out a lot
What size was the mounting bolt you removed at 0:58 ?
thumbs up!
I need help. my window works well, but the side closest to the door handle sits too low and allows water to seep through? It kinda looks like it’s handing so I’ve been using a wedge to keep it up. (Mechanics in my area are scarce and take 3-4 months to even look at my car
The replacement has plastic parts instead of metal?
Do you have a video for a 2014 model?
@TRQ
2 жыл бұрын
+Art Man We do not have a video for this repair right now, but we'll keep this request in mind for a future video! 1aau.to/m/Shop-TRQ
Why the window rattles when closing the door?
My mustang has a feature that rolls up window little more once door closes but since i put new regulator it wont do that
@cheko4440
3 жыл бұрын
Hey any idea what it is, my window is the same but it’s a bit fallen and water leaks in on the right towards the door Handle
@PowerUpAuto
3 жыл бұрын
Might need to reset the auto on the switch. Door closed, try holding the button in the up position for 15 seconds AFTER the window is already up. Might do the trick.
@dondaddapapa7143
2 жыл бұрын
Any update? Mine rolls down halfway automatically and wont roll up the little bit
How to get window up if motor is dead and window is down?
Good idea but I'm replacing the actuator because the window WON'T go up. How do i get it up?
@Jaul18
Жыл бұрын
Just came across your comment and I’m having the same exact issue on my 2010’s passenger side window. Did you find a solution to raising the window panel so the regulator can be removed?
@anthonydempsey5311
Жыл бұрын
Having that same problem. Window is stuck all the way down. How do i raise the window to get to the window mounting bracket
You didnt say anything about resetting the electrical parameters on the window which you MUST do in these cars
@nicoleadkins9945
Жыл бұрын
If you don't would it cause the window to not roll all the way down?? I just changed my regulator and followed all the steps but it still won't go down all the way
@anthonydempsey5311
Жыл бұрын
Nicole theres a video on how to reset the window that go down a little when you open the door and back up to top when you close door.
i come here just to find out what size the bolts are instead of spending 5 minutes trying each socket
The way you say vehicle bothers my soul 🥹