How to replace side mirror on Nissan Maxima without removing door panel
Автокөліктер мен көлік құралдары
Due to factors beyond the control of RB The Mechanic, it cannot guarantee against unauthorized modifications of this information. RB The Mechanic assumes no liability for property damages or injury incurred as a result of any of the information contained in this video. RB The Mechanic recommends to follow safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, chemicals, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of RB The Mechanic, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not RB The Mechanic.
#maximamirror #nissanmaximasidemirror #mirror #doorpanal #howtoreplacesidemirror #nissinmaximasidemirror #nissanmaximadoorpanal #howtotakeoutdoorpnaleonmaxima #nissandoorpanle #2008maximamirror
Пікірлер: 19
Extremely helpful but needed some extra work on an Australian J31 2007 "Maxima" which is slightly different, but the basic method works fine without needing to completely remove the liner. There is no nut securing the tweeter. It is secured by a panel pin and two slotted panel wedges. Pulling from the front will pop the panel pin but be careful pulling the two wedges, that you do not bend them "fore and aft" - only up and down. They are aligned vertically. (top one out first) The fixing behind the handle cover plate is a Phillips head panel screw (wide head). You DO need to remove the cover behind the internal door handle and unscrew this screw. You can then pull the internal door panel away from the door body so that you can manipulate sufficient space to get to the three 10mm nuts with a straight socket extension. When refitting it is important to ensure that the panel "hooks over" a small ledge on the tweeter so that it returns to the correct position against the body - i.e. so that it sits flush. Be careful when manipulating the internal door panel from below that you do NOT lift under the door bin, as the bottom pivots will drop out!!! These are two 2mm dia pins and easily lost!!! If they do come out, they can be reinserted in the bin and then carefully snapped back into the slot in the body and "seated" securely by applying careful pressure. Thanks RB
Thank you RB for another great video. Can you do a video about replacing the driver side mirror on a 2007 Ford Econoline van?
@RBTheMechanic
2 жыл бұрын
I don’t get lot of those if I come across that car and the job I will make a video
Literally stopped where I needed the most help. Great video but can't get the panel to sit back flush.....
@RBTheMechanic
Жыл бұрын
Check top lining and ur clips some times they r off
will this work same for 2012 and what is a #10 and what is a pick?
@RBTheMechanic
2 жыл бұрын
Yeah should be similar pick is long needle u can also use flathead screw driver
@BodyRockinModelsV3
2 жыл бұрын
@@RBTheMechanic what is a #10
does this work on 2013 maxima?
@RBTheMechanic
2 жыл бұрын
Yup
@cierareed7569
8 ай бұрын
How about at 2010
Can you do this on 2000 nissan maxima or do i need to take the passenger door cover off??..
@RBTheMechanic
13 күн бұрын
If I get the car I will do so not sure if u have to take it all off
@rickeymcdaniel7049
13 күн бұрын
@@RBTheMechanic yeah I was just wondering if I had to take off passenger door panel off,,if so no biggie & thx for replying back..
@rickeymcdaniel7049
13 күн бұрын
@@RBTheMechanic oh I live in Alabama..
@rickeymcdaniel7049
13 күн бұрын
I just wondering if I had to take passenger door panel off,,if so no biggie..
@rickeymcdaniel7049
13 күн бұрын
& thx for your response..