How to Replace Front Subframe SAAB 9-3 2003-2011(Part 1)
Жүктеу.....
Пікірлер: 31
@simonpalethorpe83505 ай бұрын
Would like to see you do a rear subfram.thanks
@benjammin12125 ай бұрын
Thanks..
@saabmastertech5852
5 ай бұрын
Welcome!
@Bill-lj4jf5 ай бұрын
Great video as always. How much would this job cost to remove and replace in your home province of Quebec? I was able to find esaab parts is currently selling the subframe on sale for 302 US. This appears to be a common issue in in Saab 9-3's in snow and salt road areas of the country. I have seen 2 go on sale in my area with the same issue of a rustry subframe and can't pass inspection. Thanks and keep the videos coming. If you can't quote numbers - just quote hours for the job and we can figure it out.
@saabmastertech5852
5 ай бұрын
3 to 4 hours & add 1.5 hours, if it is XWD.
@dmitrikhmelevski92144 ай бұрын
Good Man!
@saabmastertech5852
4 ай бұрын
Thanks!
@utuinc75443 ай бұрын
I'm stoked to have found your channel, thanks for the video. Are near Montreal? Where did you buy the subframe from. I salvaged one from Vermont for my 06 Aero SC, anything in the scrap yards in Quebec are rusted through/ swiss cheese. I need to do this on my 05 93 Linear. It's rusted through at the AC condensate drip spot on the passenger side.
@saabmastertech5852
3 ай бұрын
Yes, it is hard to find good subframe here in Quebec. Thanks for sharing.
@vijay_malagi2 ай бұрын
Hello, great video. Is this subframe for a convertible? I am looking for a subframe for my 2010 Saab 9-3, do you know how I can procure one?
@saabmastertech5852
2 ай бұрын
No, it is not for convertible. Check at esaabparts with the serial number of the car.
How much would a job like that cost? Asking for a friend 😊
@saabmastertech5852
5 ай бұрын
3 to 4 hours & add 1.5 hours, if it is XWD.
@bemad78863 ай бұрын
Do you have any information on how to replace the entire 2.8 engine? I've heard from the saab community that you can remove it by dropping the subframe with it. Any info would be greatly appreciated.
@saabmastertech5852
3 ай бұрын
You can find detailed info on SAAB WIS Online. Power train removal.
@bemad7886
3 ай бұрын
@saabmastertech5852 Is the WIS for powertrain removal pretty accurate? I'm just a bit cautious because I've never removed an engine before 😅, but I'm willing to give it a shot because my motor is blown anyways. And so far your videos among other have been really helpful. Your videos helped me fix so much wrong with the car. It's just too bad the head gasket blew and maybe even cracked the block 😞. But at least the frame is solid, and has all new suspension lol.
@robertrasmussen51492 ай бұрын
Hi is the motor just hang by it self after you have taken it off?
@saabmastertech5852
2 ай бұрын
The motor is held by right side engine mount & left side transmission mount. You don't have to stay under the engine after removing the subframe. If you are not sure if the engine & transmission mount are not strong enough, support the engine with a beam.
@romanrudenko16145 ай бұрын
Please , if you have chance one day - make same with rear subframe . Thank you for video ! P.S. Do you support engine from top before removing subframe ?
@saabmastertech5852
5 ай бұрын
It is better, you support the engine from the top & tie the radiators with a strap.
@user-ee7yv1gl2q
Ай бұрын
Thanks for the great video. Is it in this case, you didn’t support the engine from the top?
@S44BBOI5 ай бұрын
The best!
@saabmastertech5852
5 ай бұрын
Thanks!😃👍
@SEDAN955 ай бұрын
Ma ha fatto a marcire così ? La mia SAAB 9000 del 95 iniezione è perfetta sotto 😮
@nazarin
5 ай бұрын
È una saab usata a Montreal, Canada, dove le strade sono in pessime condizioni, così come le auto! a causa delle quantità assurde di SALE che utilizzano durante l'inverno per sciogliere il ghiaccio e la neve...
@SEDAN95
5 ай бұрын
@@nazarin ok ora si capisce perché .la mia è in Italia e non c'è tutto questo inconveniente 👍
@Miok05 ай бұрын
Shame on the Saab owner, to leave the car root like that.
@tomcom4
5 ай бұрын
The AC drips on that part of the subframe, it's a design flaw known by Saab enthusiasts (and north east winters do not help).
@Miok0
5 ай бұрын
@@tomcom4 that is 18 years of neglect
@jesusromero5217
Ай бұрын
@@tomcom4 I suppose the workaround is extending the drip pipe so it goes directly to the ground instead? I bought my 93 like this and planning to replace the subframe but I don't want it to happen all over again....wondering what everyone is doing to remedy the original design flaw?
Пікірлер: 31
Would like to see you do a rear subfram.thanks
Thanks..
@saabmastertech5852
5 ай бұрын
Welcome!
Great video as always. How much would this job cost to remove and replace in your home province of Quebec? I was able to find esaab parts is currently selling the subframe on sale for 302 US. This appears to be a common issue in in Saab 9-3's in snow and salt road areas of the country. I have seen 2 go on sale in my area with the same issue of a rustry subframe and can't pass inspection. Thanks and keep the videos coming. If you can't quote numbers - just quote hours for the job and we can figure it out.
@saabmastertech5852
5 ай бұрын
3 to 4 hours & add 1.5 hours, if it is XWD.
Good Man!
@saabmastertech5852
4 ай бұрын
Thanks!
I'm stoked to have found your channel, thanks for the video. Are near Montreal? Where did you buy the subframe from. I salvaged one from Vermont for my 06 Aero SC, anything in the scrap yards in Quebec are rusted through/ swiss cheese. I need to do this on my 05 93 Linear. It's rusted through at the AC condensate drip spot on the passenger side.
@saabmastertech5852
3 ай бұрын
Yes, it is hard to find good subframe here in Quebec. Thanks for sharing.
Hello, great video. Is this subframe for a convertible? I am looking for a subframe for my 2010 Saab 9-3, do you know how I can procure one?
@saabmastertech5852
2 ай бұрын
No, it is not for convertible. Check at esaabparts with the serial number of the car.
@vijay_malagi
2 ай бұрын
@@saabmastertech5852 tried, couldn’t find anything.
How much would a job like that cost? Asking for a friend 😊
@saabmastertech5852
5 ай бұрын
3 to 4 hours & add 1.5 hours, if it is XWD.
Do you have any information on how to replace the entire 2.8 engine? I've heard from the saab community that you can remove it by dropping the subframe with it. Any info would be greatly appreciated.
@saabmastertech5852
3 ай бұрын
You can find detailed info on SAAB WIS Online. Power train removal.
@bemad7886
3 ай бұрын
@saabmastertech5852 Is the WIS for powertrain removal pretty accurate? I'm just a bit cautious because I've never removed an engine before 😅, but I'm willing to give it a shot because my motor is blown anyways. And so far your videos among other have been really helpful. Your videos helped me fix so much wrong with the car. It's just too bad the head gasket blew and maybe even cracked the block 😞. But at least the frame is solid, and has all new suspension lol.
Hi is the motor just hang by it self after you have taken it off?
@saabmastertech5852
2 ай бұрын
The motor is held by right side engine mount & left side transmission mount. You don't have to stay under the engine after removing the subframe. If you are not sure if the engine & transmission mount are not strong enough, support the engine with a beam.
Please , if you have chance one day - make same with rear subframe . Thank you for video ! P.S. Do you support engine from top before removing subframe ?
@saabmastertech5852
5 ай бұрын
It is better, you support the engine from the top & tie the radiators with a strap.
@user-ee7yv1gl2q
Ай бұрын
Thanks for the great video. Is it in this case, you didn’t support the engine from the top?
The best!
@saabmastertech5852
5 ай бұрын
Thanks!😃👍
Ma ha fatto a marcire così ? La mia SAAB 9000 del 95 iniezione è perfetta sotto 😮
@nazarin
5 ай бұрын
È una saab usata a Montreal, Canada, dove le strade sono in pessime condizioni, così come le auto! a causa delle quantità assurde di SALE che utilizzano durante l'inverno per sciogliere il ghiaccio e la neve...
@SEDAN95
5 ай бұрын
@@nazarin ok ora si capisce perché .la mia è in Italia e non c'è tutto questo inconveniente 👍
Shame on the Saab owner, to leave the car root like that.
@tomcom4
5 ай бұрын
The AC drips on that part of the subframe, it's a design flaw known by Saab enthusiasts (and north east winters do not help).
@Miok0
5 ай бұрын
@@tomcom4 that is 18 years of neglect
@jesusromero5217
Ай бұрын
@@tomcom4 I suppose the workaround is extending the drip pipe so it goes directly to the ground instead? I bought my 93 like this and planning to replace the subframe but I don't want it to happen all over again....wondering what everyone is doing to remedy the original design flaw?