Thank you very much for your video,It was very very helpful I was stuck since I don't have a cutting torch or sophisticated tools. It's done thanks. Ernest Siamaundu zambia africa

@QA1TECH

2 жыл бұрын

Glad to hear we were able to help you!!

Thank you very much QA1.

@QA1TECH

3 жыл бұрын

Thanks!

Can they be replaced with bolts ? I dont have any fancy equipment to put new ones on

@shitbox_sommelier

3 жыл бұрын

Yes, just be sure to use appropriately graded hardware.

Try a Lenox metalmax diamond cut off wheel. 4.5" grinder. They are made for steel. Best bolt and rivet cutter I have found yet. Clean and fast.

@QA1TECH

2 жыл бұрын

Thanks for the feedback, Troy!

I use Dynomite

Great video. Question, I have a 71 C10 Stepside that is a heavy half with factory leaf springs in the back. So to install your kit I need to remover the leaf spring perches and weld in truck arm perches. Could you provide the measurement for exact weld up. Either Center to Center or off the brake backer plate. It is a 12 bolt if that maters.

@QA1TECH

3 жыл бұрын

All of the QA1 C10 suspensions systems are bolt-in. This requires no welding at all. For installation, all of the brackets locate off of factory holes in the frame. After drilling a few more holes, you're ready to bolt everything in. Check out QA1.net/C10 for more information.

You Lied . . . You Only Remove Rivet Heads . From Chassis . .Not Rivets

@billkerksiek208

2 жыл бұрын

once the head is off you can punch the rest right on through