No video

How to rebuild a hydraulic steering cylinder

This is a steering cylinder off of a Caterpillar GC30 forklift and we tackle rebuilding it because it is wore out and leaking. I show a few tips and tricks.
Email - beesprojects84@gmail.com
Facebook - www.facebook.c...
Equipment list:
Zetor 5211 - 47hp tractor
Michigan 75A wheel loader
Kubota L210 -21hp tractor
Caterpillar GC30 forklift
John Deere Z950M 72” zero turn
Bolens QT17 tiller tractor
Jacobsen Chief 800 tractor x2
Cub Cadet Original tractor
Craftsman Pro 46 inch riding mower
Sno-Way 26 series snow plow
Brute Force 22 ton log splitter
And more……

Пікірлер: 10

  • @aaabbb4353
    @aaabbb43533 ай бұрын

    Once you get yr rebuiled cylinder back on, engine running, you want to take it easy & go back & forth with it a few times very slowly. Allowing the air to get out the way without heating up, turning into foam, burning the seals. Not that you did here, just a tip for some that wldn't know. I 've learned it the hard way :)

  • @sirmister4411
    @sirmister4411 Жыл бұрын

    When I work with those hard rubber almost plastic like seals I heat up some water and put them in the hot water to soften them up just a little Make it easier to move them into where they go Looks like that piston has been apart a few times before in the past.

  • @beesprojects2692

    @beesprojects2692

    Жыл бұрын

    Yes I’m sure it has been apart quite a few times with the hours on this machine. I have also heated up those seals before. Sometimes they are just that tight.

  • @Farm_fab
    @Farm_fab Жыл бұрын

    Years ago, I worked on my boss's 1957 USN forklift. It would stop running outside in the cold. It turned out that the propane regulator cooling lines were clogged. After cleaning them out, and reinstalling them, it ran fine after that. Sometimes its the little things that make the big problems.

  • @Farm_fab
    @Farm_fab Жыл бұрын

    Crc distribution in Alabama has many parts for hydraulic cylinders, etc. In many cases, they're the same as the oem, but less expensive. I haven't used them yet, but i know some folks that have, with VG results.

  • @crypticbladez1654
    @crypticbladez16545 ай бұрын

    Do you have a video showing how to remove it because I can’t get mine out

  • @beesprojects2692

    @beesprojects2692

    5 ай бұрын

    Unfortunately I don’t have a video about that. I want to say I had a little bit of a time getting mine out though. It’s in such a bad spot. I made some solid wooden ramps that I use to back the forklift up on to so that it gives me more room to work underneath it.

  • @mclaughlinm7199
    @mclaughlinm7199Ай бұрын

    I have a same power steering cylinder but I don’t have the serial number for the forklift Do you know the part number for the whole seal kit I will really appreciate it

  • @beesprojects2692

    @beesprojects2692

    Ай бұрын

    You are in luck. I saved the receipt and it shows the part number as 9125511120. I bought it through the CAT dealer.👍

  • @mclaughlinm7199

    @mclaughlinm7199

    Ай бұрын

    Thank you so much god bless you