How to install an autopilot on a sailing yacht

This video install shows the installation of a Raymarine EV-100 Wheelpilot onto a Elan 344 Impression
It also shows the making of new parts to the steering system to allow the Wheel drive to fit the boat correctly.
00:00 Unboxing
01:18 Planning the installation
03:07 Removing the yacht steering wheel
03:58 Raymarine P70S control head
05:33 Raymarine EV-1 Sensor Core
07:33 Raymarine Seatalk/NMEA 2000 backbone
09:51 Raymarne Actuator Control Unit
10:42 Raymarine Wheel drive unit
16:00 Making up new parts to fit the Wheel drive
24:34 Final fitting and sea trial

Пікірлер: 28

  • @skippywinters
    @skippywinters2 ай бұрын

    Im so glad you posted this. This way I can straight away hire someone else to do the job I wouldn’t be able to do myself but would only come to that realization half way through the process

  • @confidencesailing

    @confidencesailing

    2 ай бұрын

    Glad it helped. And thanks for watching

  • @rockchicksdigme
    @rockchicksdigme Жыл бұрын

    Dude! Now THAT was an unboxing! 😮👍

  • @confidencesailing

    @confidencesailing

    Жыл бұрын

    No animals or children were hurt during the procedure👍

  • @ulftornert2855
    @ulftornert28552 жыл бұрын

    Well done! And thanks for sharing!!

  • @confidencesailing

    @confidencesailing

    2 жыл бұрын

    Thanks 👍

  • @et06pn0
    @et06pn0 Жыл бұрын

    Thanks for sharing!

  • @confidencesailing

    @confidencesailing

    Жыл бұрын

    You're welcome

  • @duncanbrown1864
    @duncanbrown18642 жыл бұрын

    I like the long form vids. You shousld do more, if you can!

  • @confidencesailing

    @confidencesailing

    2 жыл бұрын

    Thanks. I shall try.

  • @szymondworski
    @szymondworski2 жыл бұрын

    Nice work, well done! We have a similar crew configuration as you have. Our autopilot (which obviously has his own name) is very helpful and counts as an additional crew member :)

  • @confidencesailing

    @confidencesailing

    2 жыл бұрын

    our old boat had an autopilot called Harry the Ghost. This one is therefore called Harriet.

  • @szymondworski

    @szymondworski

    2 жыл бұрын

    @@confidencesailing Haha! Ours is called Mr. Karnowski. He is a mayor of Sopot - the town my wife and I come from. As we called our boat Sopot it seemed obvious for the mayor to helm it for us as needed! :)

  • @mattphillips9107
    @mattphillips91072 жыл бұрын

    I would've chosen a Kate over a George with the bush dilemma 🤣 looking forward to this seasons videos, keep up the great work guys.

  • @confidencesailing

    @confidencesailing

    2 жыл бұрын

    Wow!! I'm ashamed to say Kate never even crossed my mind.

  • @skyfreezr
    @skyfreezr Жыл бұрын

    ACU has to be fitted vertically so any condensation collecting on the wiring, drips away from the circuit board rather than into it

  • @recifedepeixes

    @recifedepeixes

    11 ай бұрын

    That's a good reason...

  • @Nami-Sailing
    @Nami-Sailing5 ай бұрын

    Very beautiful Video 😀 We are in the process of finding the perfect autopilot for our 30 f boat and just saw your video. After a Year, would you buy the EV-100 again? Is it strong enough for bigger waves and silent enough for a good chill? Thank you again for this video, we subscribed ;)

  • @confidencesailing

    @confidencesailing

    5 ай бұрын

    It's always a balance. If I had more money I would get a direct drive type as in big waves this one isn't strong enough. Noise wise it chatters away, but in calm conditions where you might want to 'chil' it isn't annoying.

  • @tstrandv123
    @tstrandv1232 жыл бұрын

    Hello, is this autopilot strong enough to use under sail and moderate sea conditions?

  • @confidencesailing

    @confidencesailing

    2 жыл бұрын

    if the rig is well balanced then under sail - no problems. Certain sea conditions - experienced under either sail or power - can prevent the autopilot from keeping a straight course. but its more to do with the direction of the swell than the size... beam seas are most problematic. Slowing down can help, or increasing the response level on the controller (there are 3 - leisure, cruise, performance) - sometimes just a few minutes of hand steering helps, and you can put the pilot back on and it will be fine. I owned the predecessor of this unit on a previous boat and that would frequently be overpowered - at which point the autopilot beeps a very brief alarm - and then stops operating... leaving your wheel/rudder still engaged with the motor.... quite irksome if you then get forced into a gybe before you can grab the wheel... This model has so far been pretty good - but I wouldn't want to rely on it for crossing an ocean. The P70 control head, the ACU and sensor can all be used with a hydraulic ram instead of the wheel pilot motor - and they can handle anything - but are more expensive and more challenging to install.

  • @jonnydotnet
    @jonnydotnet Жыл бұрын

    Have you thought of adding a rudder position sensor? Apparently it can reduce S ing and make the whole system more accurate....

  • @confidencesailing

    @confidencesailing

    Жыл бұрын

    My understanding was that it was pretty essential on hydraulic systems as the rudder position continually 'creeps' relative to the wheel (certainly that was the case in my last boat which had hydraulic steering) but with wire and chain that wasn't a factor so rudder position wasn't necessary. It might be an upgrade worth considering though. The 'S'ing can be a nuisance over a certain speed through the water. Thanks for the tip. I'll look into it.

  • @jonnydotnet

    @jonnydotnet

    Жыл бұрын

    @@confidencesailing Interesting you should say that as I have hydraulic steering and my system doesn't have one (I have same components as you except for hydraulic ram steering). Am thinking of adding one soon so I'll let you know if it makes a difference. Cheers.

  • @michaelmulryan2889
    @michaelmulryan28892 жыл бұрын

    Could you try and reverse the wheel ? One side maybe deeper at the hub.

  • @confidencesailing

    @confidencesailing

    2 жыл бұрын

    I thought that myself, but Unfortunately not. The end of the shaft is tapered. So it only goes on one way around. although I think the hub is centred. (I’m not on board at the moment so I can’t remember)

  • @cornelisvanderbent8569
    @cornelisvanderbent85692 жыл бұрын

    Had to laugh when Bush and Terminator appeared.

  • @confidencesailing

    @confidencesailing

    2 жыл бұрын

    because this was recorded and edited quite a while ago, I had forgotten about Bush myself - so I had a fair chuckle myself when I saw it back this morning 😂