How to check media ratio in your DIY Vapor Blasting Cabinet
Тәжірибелік нұсқаулар және стиль
I continually get asked what mixture of media should be run.
Or I end up being asked to diagnose home built systems that just don't function as they should.
This is a test I end up explaining a lot. Being short on time with all the builds keeping me busy, I figured now was a good time to squeeze in some quick edits.
Thanks for watching!
Пікірлер: 17
Very clever way to check, thank you for the tip. Something I have been struggling with the get right.
Good looking cabinet Josh... Hope you are all well over there... Regards from perth.. 👍🙏🙏
@ArmouryEnterprises
2 жыл бұрын
Thanks Greg! Yeah busy busy but doing well!
Looking good this one mate. Haven't Heard from you in a while glad you're ok Josh bud 👍
@ArmouryEnterprises
2 жыл бұрын
Hey Buddy! Yeah doing good. Just ridiculously busy. Looking forward to getting past the job list I have and getting my weekends back haha. Hope your well mate!
КРАСАВЧИК, мастер, педант, техник, благодарю тебя за труд,за силы, за видео, береги себя, здоровье, близких, просмотров 10000000!
Like that very good 👍 👌
@ArmouryEnterprises
2 жыл бұрын
Glad you liked it! Thanks for watching!
Hi Josh, do you have drawings for the stainless cabinet? I’ve set up a few a vapour blasting cabinets now using the red HAFCO cabinets but finding they are rusting out too quick. I plan to make my next one out of stainless like this one. Cheers
@ArmouryEnterprises
2 ай бұрын
Hey mate, Yes I do. I don't usually make a habit of distributing them though. Send me an email at josh@armouryenterprises.com to discuss. Cheers Josh.
What type of pump do you use. That abrasive would damage the impellar of most centrifugal pumps. Diaphram pump i imagine would be ideal for this setup.
@ArmouryEnterprises
Жыл бұрын
Pumps are centrifugal submersibles. Diaphragm pumps don't flow enough, and the abrasive wears out the valves. Even lower priced submersible pumps have shown resilience against the wear of the media, but some of the better quality submersibles have urethane impellers and oil filled seals.
Do you prefer the gun there to the Printed one?
Soo if i have 45 liters tank i need to put 9kg of media witch is 20percent?😄
@ArmouryEnterprises
Жыл бұрын
Not necessarily. There are a number of factors that will affect your mixture. Pump position, reservoir shape, pump flow, agitation efficacy. It is a good start though.
how many hp compressor do you use?
@ArmouryEnterprises
2 жыл бұрын
For small stuff, I just use a 3hp 12.5cfm unit. For the big jobs I use a 75CFM diesel compressor.