How to Apply Sheet Laminate | DIY Laminate Surface

Тәжірибелік нұсқаулар және стиль

In this video I will share my trade secrets on how to apply sheet laminate to a surface the professional way. This process can be tricky considering that a fast grab contact glue is used and once the two surfaces meet they instantly stick together leaving you little room for error. So when applying your two surfaces together you need to make sure they are aligned correctly into position. I have a simple hack that will help achieve professional results for your DIY project in your home workshop.
Affiliate Links:
Laminating Rubber Roller:
amzn.to/3H881yv
High Strength Spray Adhesive:
amzn.to/41xcRgr
Flush Trim Router Bit Set:
amzn.to/3mDtoAE
Makita 18V Trimmer (I am NOT Sponsored by Makita):
amzn.to/3KXImuZ
Recording Equipment (Please note I am NOT Sponsored by these brands in any way):
Rode Wireless Go II:
amzn.to/3IYGKOK
Rode Lavalier Go Professional Mic:
amzn.to/3J2ITcq
Sony ZV-1 Digital Camera:
amzn.to/3SRJO43

Пікірлер: 5

  • @j77364
    @j773645 ай бұрын

    Hi Geoff, thank you for providing all these tutorials! I've subscribed after watching the first video....and then proceeded to watch every single video. This is such good information coming from a pro.

  • @geoffsjoinery4990

    @geoffsjoinery4990

    5 ай бұрын

    Thanks for your support I am glad you enjoyed my videos 👍

  • @RobKernahan
    @RobKernahanАй бұрын

    Hi Geoff, nice Vid and thanks. I'm about to laminate a counter top being 3600 x 600, the contact cement i'm using is Max Bond Rapid Grip which is Brush/Roller grade. I can't find too much info as to what Roller cover is suitable. Would you have any idea what the recommended is ? Cheers Bud.

  • @geoffsjoinery4990

    @geoffsjoinery4990

    Ай бұрын

    Hi Rob, You can generally use a standard paint roller if you want to roll the contact glue on. 10-12mm NAP would be fine. You could also use a glue spreader, the kind you use when spreading tile adhesive glue on the wall or floor. Just get the smallest notches possible, say 3mm. Hope this made sense, good luck...👍

  • @RobKernahan

    @RobKernahan

    Ай бұрын

    @@geoffsjoinery4990 Thanks Geoff.

Келесі