I've googled this exact question before and all I found were snarky gate-keepers of the forbidden knowledge, and now you made this and it looks so doable. :) Thank you

@madebyjwillis

4 ай бұрын

Happy it helped!

@JennaHasm

4 ай бұрын

That is not how you should be seeing things. It says a lot about your mind. Good men, have to provide for their family. Good men will go where they will be valued. Good teachers are a rare commodity. Being a good teacher, that makes easy to understand explanations should be valued. Otherwise they will go where the market values them. I'm safe in guessing your favorite vice supplier is much more rewarded, than this good man. But you'll never admit to that, why will you. You'll take your short-sighted ego to the grave.

I’ll need to rewatch this 100 times but I really wanted to add this shaping to a box lighter case for texture. Ty for this!

Such underrated content, thanks man!

the riser for delack enclosure , right? 😅 printing right now, I'm going to apply to onshape, I wanted to use fusion 360, but sometimes I find that I have to have the paid version for certain functions

@madebyjwillis

4 ай бұрын

Yep it’s the riser - pretty sure none of this requires paid Fusion

How would one do this on a curved surface? Is it possible?

@madebyjwillis

4 ай бұрын

You’d need to use Emboss

see I've got this down, but I want to apply a rough injected-molded plastic texture to a clip I made, but cant figure it out; only textures not topology

@madebyjwillis

4 ай бұрын

Try fuzzy skin if you’re 3D printing it

The zoom in sequences are not good to look at🤢

@madebyjwillis

4 ай бұрын

Then don’t look