Home made Mill Way Covers
Тәжірибелік нұсқаулар және стиль
This video is not an endorsement for any seller or supplier. It simply shows what I was able to do with materials available at the time of making this video.
Please consider supporting this channel:
/ tinkeringnerd
Пікірлер: 21
If your working in your shop for fun, there is no amount of saved time that is worth digging out a broken tap. Just hand tap.
Good idea , the front one may need to match the travel . Looks extra long . I wonder if it could be pleated with a heat gun and a clamp or two with boards or angle iron.
@TinkeringNerd
4 жыл бұрын
Thank you. I measured the length of maximum travel and cut both covers accordingly. Heating and folding sounds like it may work. I will need to give it a try. Cheers.
if you put a small rubber bungy on each side it will help it stay folded fold it where you want the folds and poke holes through all then install bungy through all both sides it will make it accordion.
What about the cheap hangable plastic accordian style privacy doors at home depot ..you could just cut to size
@TinkeringNerd
4 жыл бұрын
Interesting idea.. except those accordions are at least 3 inch wide, not much better than what I managed to accomplish. Cheers.
Hi we're did you buy that material that you used as cover thanks
@TinkeringNerd
6 жыл бұрын
Try searching eBay “reinforced rubber sheet 1/16x24x44 tool box liner” I am not affiliated with any seller, so, you’re on your own there. Best of luck :-)
@ikecobey6268
6 жыл бұрын
Tinkering Nerd thanks
@1873Winchester
3 жыл бұрын
Ah typical, only US sellers found for reinforced rubber sheet...
@TinkeringNerd
3 жыл бұрын
I’m sure there must be some substitute for this material, in your area.
If you just roll that stuff on a iron bar and connection through a spring put it in a box as required and put a screw on the top and bottom
@TinkeringNerd
5 ай бұрын
That would be an interesting idea for a new video. The problem is metal chips getting curled in the roll, hard to clean up.
do you always use you mill table as a work bench?
@TinkeringNerd
6 ай бұрын
When job calls for it and no harm, why not?
reason why you broke the taps, was due to incorrect use. there are specific spiral flute taps for when using in a drill, that do not need reversing to clear the waste material
@TinkeringNerd
5 жыл бұрын
Thanks for watching! Like I said, I never had a problem with straight flute taps until these came along. Also, I already bought some spiral ones to try out, just haven’t used them yet. Cheers.
@lesp315
3 жыл бұрын
You should never use spiral flute tap with a hand drill. Next time try spiral point OSG tap.
Your front cover looks like a royal pain in the ass. There has got to be a better way than spending 300bucks for gortite covers. ????
@TinkeringNerd
4 жыл бұрын
I do not disagree that the front cover is a bit awkward. But, it beats spending an arm and a leg for an accordion type..
@jagboy69
4 жыл бұрын
@@TinkeringNerd Yeah those accordion covers are stupid money. The search continues. :-/