Holes Are Too Tight! ~ MintySynth Kit ~ Part 2.1

Ғылым және технология

Getting more done on the MintySynth kit.
We run into a problem, where the holes for the switches are just a bit too tight. Lucky a needle file was at hand to open them just enough to let them pass.

Пікірлер: 2

  • @thisoldplayhouse9415
    @thisoldplayhouse94156 жыл бұрын

    Thanks for posting these videos! I apologize that the holes were a little tight, and I’ve made a note to start making them bigger. I recently changed to a different brand of switches with slightly larger stems, and I also tightened up the tolerances on my CNC, which resulted in slightly smaller holes without me realizing it. I’m glad you were able to find a good solution, and I hope you enjoy the kit! -Andrew, MintySynth

  • @TheDutyPaid

    @TheDutyPaid

    6 жыл бұрын

    It was not much of a problem, always fun when there is a small issue to think over and solve. The kit is all finished and working now, with 2 more videos to post. I enjoyed making it a lot and now learning how to use it.