Got a new CNC torch for my Arcdroid
Тәжірибелік нұсқаулар және стиль
I bought a new CNC torch for my Primeweld Cut 60 to use with my Arcdroid. I install, calibrate and do some test cuts. I was planning on testing THC with the Arcdroid but I failed to get that unlocked. Maybe next time.
Пікірлер: 17
It is nice seeing your shop progress and improve. This is all stuff I would like to so, myself, at some point in the future as I can afford to do so. Good video, very helpful. God Bless!!!
@6.8liter74
Ай бұрын
Thank you
Thanks for the calibration demo
@6.8liter74
Жыл бұрын
Hopefully it helps someone!
I'm not planning on getting an Arcdroid but know someone that wants one. I skimmed through the manual for him and notice Arcdroid uses divided voltage for THC. However, it does not state at what ratio. Why did you go with 1/50 over 1/16? Can raw be used instead?
@6.8liter74
7 ай бұрын
I haven't implemented THC. I started looking into it but the output from my Primeweld Cut60 is not acceptable for use with the arcdroid. I do believe it uses 1/50 voltage. @amp_mechanic has some good videos of what he did to set up THC. He ended up building an external voltage divider, which I believe he sells now.
Did you ever figure out why the Droid shut down and you got shocked?
@6.8liter74
5 ай бұрын
I believe it was the unshielded cat 5 cable. It has been quite a while since it has happened.
i see on arcdroids website it says not to use high frequency plasma machines.. have you noticed any issues?
@6.8liter74
Жыл бұрын
I've had no issues, and I noticed the Primeweld cut 60 has been added to the approved machine list for machines built later than 2021.
@kwikschannel4371
7 ай бұрын
The CUT60 is not a high frequency machine.
@adam-oz1jo
7 ай бұрын
@@kwikschannel4371 oh the website says its a high frequency no touch start
@kwikschannel4371
7 ай бұрын
@@adam-oz1jo it shouldn't, it's a blowback type. I own one as high-frequency cannot be used for CNC.
How much are arc Droids
@6.8liter74
11 ай бұрын
$2500 for the arcdroid + your plasma cutter
Too many toys to buy, not enough money!
@6.8liter74
10 ай бұрын
Amen to that!