🤩🤩🤩🤩

Very well done! What filament was that?

What if instead of these connector pins one were to include small metal ball bearings, and just glue a pin into the bearing hole. Would it make the entire thing run smoother?

mine did not print the numbers on the bottom of the gears...is there any way to tell them apart?

Has anyone tried to make one of these in metal? I would like to try it, but I wonder if the pieces would "snap" together.

@Ri0m0

Күн бұрын

It would definitely work, but you might need to 3d print the connectors.