Striping out hydraulic leaver to fit new seal on my 1955 Major tractor
Жүктеу.....
Пікірлер: 6
@Kake842 жыл бұрын
Need to do same job my major sometime too. Thanks for video.
@MarshallSmart
2 жыл бұрын
part 2 next Saturday
@jameskeogh79182 жыл бұрын
was looking at your video again last night from that time as u didn't say anything about the bushs i presumed u just replaced the pin new bushs need reeming think i will just replace the pin as well thanks for info marshall no need to send me link to video j
@MarshallSmart
2 жыл бұрын
Ok np glad to be of some help 😀M
@jameskeogh79182 жыл бұрын
hi marshall hope u you are in good health . mine was leaking there also had to do the same job . have a question for u did u replace the conrod bush's and pins in the major there is a bit of wear on mine slightly tighter with new pin in it's another one of those jobs that's not easy to do j
@MarshallSmart
2 жыл бұрын
I assume you talking about the small end At the top of conrod? There were new pins came with the new pistons but the bushes were ok if I remember right. I’ll find the video later on today and send you a link. It will remind me what I did. I just found old piston and the gugen pin is it. So the gugen pins were replaced. As to my health good days an bad. 😀M
Пікірлер: 6
Need to do same job my major sometime too. Thanks for video.
@MarshallSmart
2 жыл бұрын
part 2 next Saturday
was looking at your video again last night from that time as u didn't say anything about the bushs i presumed u just replaced the pin new bushs need reeming think i will just replace the pin as well thanks for info marshall no need to send me link to video j
@MarshallSmart
2 жыл бұрын
Ok np glad to be of some help 😀M
hi marshall hope u you are in good health . mine was leaking there also had to do the same job . have a question for u did u replace the conrod bush's and pins in the major there is a bit of wear on mine slightly tighter with new pin in it's another one of those jobs that's not easy to do j
@MarshallSmart
2 жыл бұрын
I assume you talking about the small end At the top of conrod? There were new pins came with the new pistons but the bushes were ok if I remember right. I’ll find the video later on today and send you a link. It will remind me what I did. I just found old piston and the gugen pin is it. So the gugen pins were replaced. As to my health good days an bad. 😀M