Hi mate, Have sent you a message on TC forum, Hopefully speak soon. A

Hi, I have a autel mk808 My ford connect 2003 does not see my key more, the engines turns over but doesn't start as immobiliser has cut fuel I get to the point where it asks for incode but where do I get this? Also is there a limited number of time incode can be entered correctly? Can I get looked out completely Appreciate any help thanks

@PaulsTechChannel

2 жыл бұрын

If your 2003 Connect is a TDDI (Bosch VP30 fuel pump). EDC bolted to top of fuel pump are prone to failure. Resulting in engine fails to start (crank but no start) & immobiliser light flashing. Its advisable to have DTC's (Error codes) read 1st. To rule out above fault. Ford incodes are available here - www.fordradio.codes/pats/

@TheDrivewayExperiment

2 жыл бұрын

@@PaulsTechChannel thanks for the response I read all the codes - Fuel rail low pressure - 3 x codes for anti theft key not recognised I used that sane generator for incode and the autel tool came back with invalid code It Also said any more attempts could lock it out....can it lock out? One more thing, I noticed you had the 20 minute security wait my tool just Sat's please wait but you can press ok to go to next page (nothing about 20 mins) do you think I need to wait 20 minutes?

@PaulsTechChannel

2 жыл бұрын

@@TheDrivewayExperiment Tool I used in this vid - Snap on solus Pro. Does not require incodes to access PATS, Due to that it requires a 20 min delay. If your tool is requesting incode It should provide you with a Outcode which must be entered to generate incode. Once you have incode, entrer it into your tool to access PATS. It should then grant you immediate access with no time delay.

@TheDrivewayExperiment

2 жыл бұрын

@@PaulsTechChannel ahh maybe I used the previous given out code which would make this incode invalid as I understand it the outcode it gives you is generated there and then Thanks for the help!!!

@PaulsTechChannel

2 жыл бұрын

@@TheDrivewayExperiment Every time access to PATS is requested. A new outcode is generated, which then must be used to generate new incode.