i can hear the utter excitement in the voice.....all you need now is a TX and you will be away with it. :) i share your excitement as i am now also at this same stage in my radiomaster life experience.

@JustFPV-net

Ай бұрын

Let’s go and fly ;-)

Mine is on the way. Should have it Monday. Can't wait for the power output.

@JustFPV-net

Жыл бұрын

The power doesn’t matter … it’s how you have to deal with it to make it run. And this has been totally uneventful - so … guess you’ve ordered a pretty decent piece of hardware, Dan ;) Have fun with it

Can the drone fly with the computer keyboard when connected to the computer via USB?

I can’t find Radiomaster TX16s 2400 TX in my drop down. Do you know why this might be?

I bought Radiomaster Nano Module elrs for back pack Zorro. What is same as your build&flash Micro Module?

@JustFPV-net

Жыл бұрын

Should be exactly the same way to flash the module.

Can i use this to repeat my wifi wireless to another home across the street?

@JustFPV-net

Жыл бұрын

no .. that won't do! It's not a repeater ;) ...

1:53 sec mark - lol, hahahaha!!

@JustFPV-net

Жыл бұрын

Sh#t Happens ;-)))

@Seii-FPV

Жыл бұрын

@@JustFPV-net - it's funny as hell! :) Would you mind sharing your LUA script settings (Packet rate, Telemetry ratio, TX power, do you use Dynamic or not, etc.). I have Ranger Nano with my Radiomaster Zorro, and I've noticed quite lower RSSI values at the same distance, than with Zorro's built-in Tx. I'm guessing something is not set up right on my side when it comes to external module. It works perfectly fine, updated without a single problem, new LUA script that was compiled, uploaded to the SD card. All good in that front, I am just wondering what other people use inside those settings. I don't fly far, maybe 300-500 meters away, and it's above my neighborhood. I understand there is tons of interfering WiFi below... but built-in Tx does not seems like it gives me bad signal. If nothing else, external one should be the same, not worse.

@JustFPV-net

Жыл бұрын

Hmm ... not that much to share tbh! But yes, I use DYNAMIC power starting with 10mw. For the wings I go for 100Hz/FULL with 16channels. My Quad uses 250Hz or so ... Packet rate as low as possible depending on how much telemetry you might need.

@Seii-FPV

Жыл бұрын

@@JustFPV-net - Thank you! I keep pocket rate the lowest possible, and 100Hz Full, but I've heard mixed opinions about Dynamic, so wasn't sure if I should enable it or not. I've heard there is quite a delay in auto-switching, especially if we're talking about freestyle flying, bandos, etc.

Nope mine didn’t work either

@JustFPV-net

Жыл бұрын

sad to hear!

Cant make it work :((((

@JustFPV-net

Жыл бұрын

what happens?

@petrpolak8875

Жыл бұрын

@@JustFPV-net I tried to follow few videos how to flash the firmware and make it work with tx16s but not succesful. Cant get bind with the mobula 7 which has elrs. At least the module is blinking

@JustFPV-net

Жыл бұрын

we have to separate some things here to pin down the problem. 1) Did you flash a V3.1.2 on the Ranger? Did it work? 2) Which version is the Mobula7 ? is it SPI ? 3) can you bind other receivers (also on V3.1.2) with the Ranger?

@petrpolak8875

Жыл бұрын

@@JustFPV-net 1) yes expresslrs configurator 3.1.2 2) mobula show in betaflight SPI Rx, SPI provider expresslrs 3) which other receivers???

@JustFPV-net

Жыл бұрын

Just found your problem: "Mobula7 HD 1S ELRS compatible with X12 ELRS V1.0/V2.0/V2.1 flight controller" Since you flashed ExpressLRS v3.x you wont be able to bind to the mobula7 as it only supports V2.x and needs to be flashed via Betaflight.

Why spend 30% of the video taking the module out of the box??? What a waste of cycles. I believe the manufacturer knows how to package the module properly, I want information on setup and programming not packaging!

@JustFPV-net

6 ай бұрын

its a part of the video ... there is nothing much to tell about ExpressLRS hardware besides : Works or doesn't work :) Depending upon how YOU want to set it up it is an entirely diffenrent story :) So I'll keep it to the main part, where I can reach all of you!

@bungle6334

3 ай бұрын

@chuckwain5591 Longer videos = more ad revenue

@JustFPV-net

3 ай бұрын

@bungle6334 not really true … you may want to check the length of the videos and figure out that they don’t have a specific length … pretty individual.