Saw this video as my rear PTO would not stay engaged. When the tiller hit dirt the PTO would just stop. So based on this video I looked at the release valves which are pressed down by a plate with the knob so one can move the tractor without power. The plate on mine was permanently bent and was partially engaging the release valves. So took it off, cleaned it up, bent it back a bit in the vice and now the tiller chews through anything. Thanks for putting information out there on an old but super useful product!

I enjoy your videos

@mikestarcher

11 ай бұрын

Thanks

You can disassemble those valves incase you didn't know to clean them really good

@frankwolf6920

2 жыл бұрын

is there a video on that anywhere ?

Have a 317 that I bought from original owner. It was repowered with an Onan p218g engine. Have used it for several years now with no issues. Would be nice to have power steering.

I don"t want to say much about the 317. However the 317 was the reason Deere came out with the 318. The Series 1 engine had a lot to do with that. There are 317's out there with Onans in them as there was problems getting the series 1 problem fixed in a timely manner. This may have been a Kohler problem. There was an aftermarket power steering unit available for them. The series one problem may be fixable or may have been repaired in your unit. You may be able to find out by checking with Deere or Kohler. When your in there doin the rings make sure you fix the series 1 problem.

Very Nice Tractor, Mike. Was the engine the original KT17 Kohler? I think that tractor was probably owned by the railroad at one point judging by the stenciled numbers that were painted on. More than likely, The PTO sustained a very bad shock like hitting a very solid object while the PTO was fully engaged. The PTO shaft splines and the fan blades pretty much tell the story - With that kind of shock, Something had to give. I am really looking forward to seeing your upcoming video showing the tiller in action. Does your 317 steer as sharply as like the 110 John Deere tractors did? The 682 Cub Cadets were pretty similar to the 317 John Deere tractors but I never did like the steering action compared to the John Deere tractors.

@mikestarcher

2 жыл бұрын

It was never owned by the railroad to my knowledge I bought it off the 2nd owner who bought it to resell

hey Mike can you tell me where the oil drain plug is on the engine

why when you had it apart blow the dirt away and clean it up

@mikestarcher

7 ай бұрын

So it stays clean

Can you do a video on how to assemble the brakes?

@mikestarcher

Жыл бұрын

Don't have any apart right now but I'll do a video if I get to one

Did you pour any hydr fluid in the case directly once the valves was out

@mikestarcher

9 ай бұрын

No

Is that a kt 17 series 1 or 2 ?

@mikestarcher

2 жыл бұрын

1

How did you know that they were stuck?

@mikestarcher

2 жыл бұрын

Tractor would not move

Would you be willing to sell a part off the bad 317 pto. I need the part that attaches the pto to the transaxle. The piece you knocked the pin out of.

@mikestarcher

2 жыл бұрын

No

@mikestarcher

2 жыл бұрын

I don't think I have it anymore

What kind of oil goes in the part where the valves are

@mikestarcher

Жыл бұрын

Which valves? The ones in the engine or the ones in the transmission

@emarionjackson

Жыл бұрын

@@mikestarcher transmission

@mikestarcher

Жыл бұрын

@@emarionjackson Low viscosity high guard hydraulic/hydrostatic fluid

are there bearing that could replaced looked like it was pretty loose or sloppy to me

@mikestarcher

2 жыл бұрын

Could replace one bearing but the rest of the shaft was wore out too so wouldn't be worth it

@frankwolf6920

2 жыл бұрын

@@mikestarcher ok thank you I'm getting ready to try to find a rear pto for mine

@mikestarcher

2 жыл бұрын

They are extremely expensive

I guess don’t quite understand why you wouldn’t power wash that whole area under the seat pan while you had it off?? Not to mention thoroughly cleaning around those relief valve’s before removing them! Not to smart in my opinion!!

@mikestarcher

Жыл бұрын

I did clean Around Them, I don't have a pressure washer wanna buy me one?

@tommckeemckee9865

Жыл бұрын

At least blow the area off with an air gun.

@mikestarcher

Жыл бұрын

@@tommckeemckee9865 you know just because you didn't see it in the video doesn't mean it didn't happen

@coppertuber

Жыл бұрын

@@mikestarcher