That's a collectors item! Thanks for sharing!

Also possibly soft contact between the hinge due to a bit of rust which sand blasting might of missed...

Its from a 1/4" drive socket set. I have my dads and still use it to this day. Nice work for first attempt.

@garageshopminnesota

Жыл бұрын

Thanks!! Thanks for watching!

I have wanted to try this as well...same with sand blasting... the color and finish is certainly next level compared to the rattle can! No doubt you'll figure it out as you always have awesome end items!! Look forward to.more of it!!

@garageshopminnesota

Жыл бұрын

Thank you for the kind words and thanks for watching!

Sweet 👍🏻 👍🏻

@garageshopminnesota

Жыл бұрын

Thank you!

I believe stainless steel is a less conductor than rebar wire to be honest...

It probably didn't get covered because it had contamination in that spot. You should out gas before you powder coat any part that has come in contact with grease or oil. On the hinged part, the top and bottom were too close together. Possible Faraday effect. The powder was being repelled. Open the hinge more and connect to a better ground. The ground on that gun isn't the best.

@garageshopminnesota

Жыл бұрын

Thanks so much for the feedback! I really appreciate it.

How was the cleanup after?

@garageshopminnesota

Жыл бұрын

I used my compressor to clean up after, so I definitely need to build some enclosure.