Fabricate a double sided ESP32 PCB using the Carvera Air
Since our first machine, Carvera has been the go-to machine for making PCBs on your desktop without messy and dangerous chemicals.
With Carvera Air, we're taking the PCB-making process to new levels, you can even make silk-screen on your PCBs!
Check the Carvera Air here on our active Kickstarter page:
www.kickstarter.com/projects/...
Early Birds are starting to run low, don't miss out on the fantastic discounts and this once-in-a-lifetime opportunity!
Пікірлер: 8
so will the carvera air have air assist or is that still in the works.
@ReactiveWork
2 ай бұрын
It will have built-in supply lines + nozzle but you have to provide your own air supply.
@DoRC
2 ай бұрын
From what I've seen it'll have the same setup as the original Carvera.
It appeared on both sides there was nothing clamping the pcb. Is this correct or was there some adhesive on the spoil board?
@Makera
Ай бұрын
Double-sided tape was used.
What software do you suggest we use?
@Makera
28 күн бұрын
We have our own CAM software coming out very soon. But other PCB CAM's like CopperCAM and Flatcam also works well.
It would look a lot better if you actually took your time with the soldermasks. Using silk screen cloth and a squeegee gives a much better finish than the roller. Also can this machine achieve 0.05 line widths as demonstrated by the channel wegstrcnc?