Ep 12. Welding stringers

Building a CNC Marine 6510cc Plate boat.
Very slow because you can't weld in straight runs you have to move around the boat so you don't heat up one area too much and cause warping. This was done over several days, over several weeks. Its been very humid and I was trying not to weld structural places in 99% humidity. Anyway got the stringers down then a quick look as I start the transom.

Пікірлер: 5

  • @marcianmoon6143
    @marcianmoon6143Ай бұрын

    what welding mask did you use ? did it have an air filter? is filtration any good ?

  • @MHD-Fishing

    @MHD-Fishing

    Ай бұрын

    I used the Unimig PAPR filter system when doing alot of welding especially in the boat. I also had an extraction fan to remove gas and smoke. When I do a quick weld and don't use the filter I have noticed it makes a huge difference.

  • @marcianmoon6143

    @marcianmoon6143

    Ай бұрын

    @@MHD-Fishing cool thanks , do you think its doable by a single person? have you built boats before?

  • @MHD-Fishing

    @MHD-Fishing

    Ай бұрын

    @@marcianmoon6143 probably more. When I get a helper a lot more gets done. No never built a boat before. I have done an aluminium boat building course.

  • @marcianmoon6143

    @marcianmoon6143

    Ай бұрын

    @@MHD-Fishing im planning to do the course too this year, i was thinking of starting with a smaller project first , maybe 4m dingy or CC. and then maybe 5.5m hard top