What a decent reliable human straight forward to the point!! Calm and truthful to the point.. A very good video indeed.. All the way from (Namibia). Bless you!!

Old video, but food for thought: 1) A dirty EGR is still more trouble than slower heating up. Cleaning it out is a major pain in the butt because it's behind the engine. It's just a big hassle. And if it gets clogged up, prepare for all sorts of trouble. 2) You can always install a heater into these cars. I am not sure about your 1.8 TDCi , but my car had the Webasto heater option installed on it. You can get the whole heater part, used, from these people who hoard parts. It's pretty cheap. In cold you can heat up the car with a remote, and the car also auto-starts the heater in colder weather, so the car is toasty in minutes. I highly recommend this upgrade.

@gurdevsingh8534

7 ай бұрын

Would a dirty EGR mean u would consume more fuel?

@KillerTechniques

6 ай бұрын

@@gurdevsingh8534usually yes, the fuel efficiency is worse.

If putting cardboard in front of the radiator helps, it's possible your radiator shutter system is stuck open. If anything, blanking the EGR should result in the engine running warmer. The EGR is designed to recycle exhaust gas to reduce combustion temperature in order to reduce the oxidisation of nitrogen.

Also it is possible you have a slight stuck open thermostat I had the same easy to tell squeeze the top and bottom radiator hoses while engine is cold if you don't get resistance it's open

HI, I am also thinking of blanking out the EGR on my 2007 Focus 1.8 tdci since it sometimes causes power drop at around 1700 rpm and also causes the car to shake when the enigne is hot and idling (I already replaced the engine mounts). My daily drive is about 18 km one way and the engine is alreday slow to warm up on this route since the route doesnt include a lot of acceleration or highway driving. Engine oil in all cars warms up even slower than the coolant (it can take 30 + km to reach working temperature during the winter) and that translates into higer viscosity and more wear and tear in the long run, so blanking the EGR would just add to the problem of slow warmup. Therfore I think the solution of attaching some kind of blanking plate (I would use metal or plastic) over a part of the radiator to compensate egr delete is not a bad idea at all. Even ford used a blanking plate from transit van to cover part of the intercooler on the focus RS mk3 (google it!), since the cooler was too efficient and caused condensation in the intake system at low ambient temperatures. You can also make a blanking plate system that is easy to attach and remove and have it on during cold months and remove it during summer. I will report back my findings if I decide to go for it on my car. Great videos by the way really enjoyed all the ford related ones, lots of useful information!

Good video 👍🏻

You could just get a thermostat that opens 5c sooner and leave egr blanked for the benefits

Do you still have mondeo? I have blanked EGR valve 2 years ago and engine is still runing with no problems. During the winter when outside temperatures are low it needs little bit time to warm up an the engine is little bit louder till warm up a little bit. Probably you will also hear occasional injector rattle around 1500rpm under load.

I have a Ford focus 2006 1.8 tdci, blanked the EGR (software and hardware) 5 years ago, temperature never reaches 90 degrees since then.

Mine with egr blanked is too agressive, but with egr free, it is smooth driving, i m confused , it s weird, i can t decide to run with or without egr . But anyways, great video man!!!

you got a cool running thermostat because I had the same issue, I changed mine to a genuine ford, and it reaches temperature beautifully, also your power drop might be due to the turbo pressure control valve actuator, again I changed mine, and power was restored. As for my EGR, i never blank it, the engine runs in sync, if you disturb that sync it will effect something else. I just replaced mine, should be good for another 100k

@jaredmayer3960

2 жыл бұрын

Nope, EGR has no impact on anything.

@joem21292

Жыл бұрын

Literally wrong egr can be deleted off any car without problem and sometimes it will throw a engine light that's only if the ecu itself measures the airflow from egr this also can be deleted by someone who does remapping

See this vidoe was posted around two years ago, although someone may be able to offer insight on this, what if one was to drill say .375 inch hole in blocker plate for a "partial block," to allow some gasses to recirculate? 💡

13 kilometers is still way too long for an engine to warm the coolant properly. Something else is off here. As stated before in the comments, blocking the EGR will result in higher combustion temperatures. This does not automaticly mean higher coolant temperatures tho. Oil temperature is what you would want to know. Low oil temps will give less lubrication and more engine wear as needed. I would replace both thermostats for OE Ford ones(yes, there are two on these engines) and see if this cures the issue. Also, that firmware update is always a good thing to do.

@kucharlubo

5 ай бұрын

The 1.8 TDCi takes longer to warm up to its optimum operating temperature than other engines because it is not of aluminum construction but a cast iron engine block. And one more question. Where does the 1.8 TDCi have the second thermostat?

Hey dude. You seem genuine. I have a golf 4 1.9tdi ALH. I see many videos about the temperature and the catalictyc getting red-hot. Should I do it? I want to do it!!!

@Taelau

Жыл бұрын

Hey man I have the 1.9TDI ASV did you end up doing it?

You can actually re route the egr coolant pipes straight from outlet to inlet instead of it running through the egr so the engine doesn’t take longer to heat up

@kevinhillier2085

Жыл бұрын

Do you know where the coolant pipes go to? Someone has taken mine off and I’m trying to work out where they should go to

@stevenmckinlay4478

Ай бұрын

Just remove inlet an outlet and use pipe to join. You are taking out the egr cooler.

EGR was very good in decreasing nox but it's not suitable in Philippines because it's hot weather while US was cold weather .so it's better in U S but most likely not suitable was carbon deposits in the intake manifold,t/c was usually design for very high temp.i think it will not damaged T/C unless it it design by very poor material,air intake was design to adjust close or open that's probably cause engine performance ,when EGR returns exh.gas to the engine ,air intake was also functioning vacuum controlled by computer to reduced nox when weather was hot or cold,so when EGR was blocked ,intake air must be always at full open to remain engine performance less air more fuel would make engine overheat or cold.

Because you haven’t coded it, your engine is expecting additional heat via egr. When it doesn’t receive it, it cools too much. Will also be stopping your DPF regenerating properly

@IV-A

Жыл бұрын

2008 1.8 tdci has no dpf

@BlackBullPistol

Жыл бұрын

1.8tdci LYNX engine has no DPF only a Cat

Hi my name is Alex, ive got my ford mondeo 1.8 tdci 2008 ffba code, my car when the engine is warmed and drive it around 80 km and push the car to the limit over 120km, and force drive more agresive the car just make like a push and nothing happen, i dint find a solution, your make the same is like you drive at 80km/h and than acelerate over 130 or more agresevile when the engine is warmed the car make like a push and nothing this happen every time i drive agresevely if a drive slowly nothing happen

Good video! Well if your engine never reaches perfect working themperatur is not good over long time, because the oil will not perform propperly. The wear in the barings and pistons is bigger. However, I just found some YT-video where they using blanking plate with a some 7mm wide hole in it. So this sounds for me as a good compromize. Not completely blocking the AGR but reducing the flow down to about 25% or so. Like taking the best out of both worlds. With that you have at least some EGR flow to help the engine reaching its optimal working temperature but without gettin too much carbon deposits in your intake manifold and valves. I gonna make a ERG blanking plate with a 7mm hole in it for my Hyundai H-1 2,5l Turbodiesel this evening. Will see If I feel any difference.

@bambiwinner7858

Ай бұрын

Results ?

I replaced my EGR with a new one. Indeed it was an expensive part, but no more issues since.

@bmw12347

2 жыл бұрын

With bad egr, did you get transmission fault warning?

@Paul_ADN

9 ай бұрын

i get... my light ESP turn on.. low circuit EGR @@bmw12347

@kucharlubo

5 ай бұрын

I want to ask you if you also had a problem with the engine warming up for a long time and that is why you replaced the egr valve? And after replacing it, was this problem solved? I am asking because I also have a 1.8 TDCi, I have already replaced the thermostat with a brand new Ford OEM part, I have replaced the coolant temperature sensor and the engine is still hard to warm up in cold weather. Even cold when driving downhill... Thanks in advance for your reply.

Hi all, I'm looking to blank my vans egr, but the research I've done shows the engine runs slightly hotter when blanked not colder... it states because it gets more oxygen it burns the fuel more efficiently thus providing more power, which in turn produces slightly more heat? With this added heat it helps reduce them coking up as much helping to prolong the life of the cat/dpf but reduces turbo life slightly due to it running that little bit hotter so adding wear there. Not feeding the engine it's own fecal matter helps keep the oil cleaner for longer causing less wear internally. Overall it's a trade off but I think it's definitely worth blanking the egr off as there are more benefits than cons, even though it's slightly worse for the polar-bears (I hope they accept my apologies). Have I missed something here or do I have the wrong end of the stick? TIA

@johnwaldrop3211

2 жыл бұрын

Your good, go ahead and delete it.

@alanjm1234

8 ай бұрын

Yep, the EGR is supposed to reduce combustion temperatures in order to reduce the production of nitrous oxide. So blanking it would result in higher combustion temperatures and a quicker warm-up.

But these engines never over heat, on surprised you didn't have any turbo issues

Termo is toast

I have a taxi it’s a Toyota avensis I.6 diesel d4d. EGR and EGR cooler gets clogged up every 10 thousand miles gets expensive to get cleaned so often. Would you recommend getting it blocked off 🙏🏻

@Mr330d

Жыл бұрын

That’s BMW engine with DPF you cannot block the EGR without deleting the DPF it will not regen properly and cost 1000s

@thomasdutton4600

Жыл бұрын

@@Mr330d apparently been quoted by few mechanic’s £150 to get computer remapped

Can I just Block my EGR without ECU remap and with Check engine light in my 2018 hyundai Creta 1.6 CRDI ?

@maticstante435

2 жыл бұрын

You need to do remap or you kill the engine

@mladenfrank2613

Жыл бұрын

@@maticstante435 please explain why?

your dmf will go sooner if you drive st so low rpms. I usually drive 1700 rpm to save the dmf and my pocket in the long run

@trymhammerstrmgisiger1278

3 жыл бұрын

very nice video tho:) informative

you didn't have a check engine error when you were blanking an EGR?

@motorsme5370

3 жыл бұрын

No, this engine is one of the rare examples where it wont pop a check engine light.

@dumbf7604

3 жыл бұрын

I get a check engine P404 code and my egr is stuck in closed state…can I continue driving without issues or should I replace the valve ?

@gazsto9510

2 жыл бұрын

@@dumbf7604 Did you solve the problem, new blanking plates have a 7mm hole so more a restrictor than a blank, but seem to work a lot better allowing some exhaust gas through and reducing to about 20%

Your driving you should of done it from idle for a more accurate test

Your thermostat is toast. It should warm up regardless. And 75 is really cool for a Diesel engine. Should be more like 95 degrees.

@BlackBullPistol

Жыл бұрын

95 on this particular engine no chance. I have the same 1.8tdci and it sits at 87°C like he said, max 90°C in summer when I push the car to the max :-P but yes 75 is definitely to cold

@ronanrogers4127

Жыл бұрын

Depends on the diesel. My old Mitsubishi 4M40 2.8LTurbo runs at 76c. I have a thermocouple on the thermostat housing and it sits on 76, hits 80c after a long climb.

You need to test the engine oil

What about fuel consumption ? Did you notice some difference ?

@_lugg_9270

Жыл бұрын

About 0,5-0,7l less consumption

Its the water not the engine oil

How can it make a difference to engine temperature when the water still flows through EGR cooler?

@zernestro

2 жыл бұрын

The EGR isn't heated that much? Because the flow is restricted... i suppose.

@ef3675

Жыл бұрын

The coolant still flows in the EGR cooler but the exhaust gasses do not. They carry the heat and the water takes it. Once the valve has been blanked, the air inside the cooler become stagnant and stays pretty much at the coolant temperature.

@Chris-jy3dm

Жыл бұрын

So that’s a good thing then?

@ef3675

Жыл бұрын

@@Chris-jy3dm Staying cold for too long isn't exactly a cure-all for a diesel engine, but my ancient TDDi doesn't even try to warm up below 70 km/h, so can't be much worse than usual.

Put a mm hole in the middle.