Endgrain cutting board
In this video I will be showing how I made two ingrain cutting boards out of one piece of walnut. The walnut board was roughly 6 inches wide by 122 inches long and 2 inches thick. I made two end-grain cutting boards approximately 12 inches by 24 inches. This video details a juice groove and handle grooves on the bottom. I finished sanded the boards from 100 grit to 320 grit. Before applying mineral oil, I cleaned all surfaces with mineral spirits. Once the mineral spirits were dry I used Howard's cutting board and Howard's butcher block conditioner.
Пікірлер: 5
Nice job,congratulation the Brazil.
Nice job on the boards!! What do you do to work around snipe from your planer or do you have your planer set up to produce no snipe at all?
How do you like that wood master drum sander ? Is that the single or double ?