Dynojet Power Commander V Install ZX6R
Автокөліктер мен көлік құралдары
Shop Dynojet - www.jpcycles.com/dynojet?utm_...
Dynojet Power Commander V Features Include:
• The PC-V has a reduced size from PCIII usb (less than half of the size of PCIII)
• Gear and speed input to allow for map adjustment based on gear or speed
• Analog input allows user to use any 0-5 volt sensor and build an adjustment table based on input such as boost or temperature
• -100 to +250 fuel change range wich allows more adjustment range for 8 injector bikes
• 10 Throttle position columns (up from 9)
• You can switch between 2 maps “on the fly” and maps can be adjusted on a “per gear” basis ( one map per cylinder, per gear, if required)
• Allows for adjustment of fuel and timing based on engine temp through the “cold start feature”
• Will power up with USB cable only for programming purposes
J&P Part: 160-3033
Need help removing the tank and airbox? Check out the K&N Air Filter Install Video here:
• K&N High Flow Replacem...
#Dynojet #powerCommander #MotorcycleTuning
Пікірлер: 31
See more how to's on Countersteer - www.jpcycles.com/countersteer?Dynojet_Power_Commander_V_Install_ZX6R&I3GaNF_f_As
I used your video, not to install a power commander, but to change my spark plugs! It honestly is the clearest instructions for taking off the gas tank and air box! Thanks!
This is an excellent installation video. Just finished installing the PCV on my bike 2017 Zx6r. Took me nearly 4 hours 🥵. Thank you so much for making this video and being so thorough
Awesome tutorial video. I want to install a power commander eventually but I watched this to help with being a little insecure on how to properly remove the gas tank and air box for a different install!
Great video. Thank you
Great video, favorite part of installing is when finish and start your bike and the dash looks a Christmas tree , make sure all those connectors click or youll have a mild stroke when see all the lights on your dash ...good times ...
Does a power commander let you change the STPs and ignition timing?
next week im going to get an ecu flash/tune on my 2020 zx6r... should i also get the power commander??
Does PVC from zx6r 2007-2008 fits to zxr6 2009? It has all the same wires except the “blue“ one (at 8:43 )?
hey, i noticed the Gear Input & Analog input cables were worn out. I took them out to cut a bit and put them back in but now I forgot in what position they were connected. I have put them in according to the fold of cables, but the question is; would it be remarkable if they were wired incorrectly? Thank you.!!
@6:50 that screw is STRIPPED! Lol!
I have like 9 of those 3hp stickers on my bike. Butt dyno says YEAAAAHHHHHHH!
Nice make more videos about fixing zx6r 13+
Second question at 6:10 what are those two plugs in the tail section? I didn’t have them on my 05. Thank you
@m.d.bishop1244
4 жыл бұрын
@Val Kyrie Thank you
Can i just pay them to install it
When I disconnect the main fuel line how much fuel can I have in the tank? Does it need to be empty or does the pump keep it from running out? Sorry I know for some this is a simple question.
@TheStickfigure007
4 жыл бұрын
The pump will keep from running out, it can be full itll just be heavier to maneuver
Where did you connect the power?
@vincently1231
4 жыл бұрын
posi tapped it to the gear position sensor
@vincently1231
4 жыл бұрын
8:39
At 8:23 talking about the throttle position sensor, I unplugged the power one, then plugged in new female plug, but where does the original male plug go???
I have a 2020 ZX6R is this the same process?
@leohanna954
4 жыл бұрын
Let me know if you find a answer, i need it
@king_of_636s
4 жыл бұрын
@@leohanna954 I did. It's the same. Pretty simple. You only need like 2 allens and a phillips head.
@leohanna954
4 жыл бұрын
Anthony C nice, happy to hear that. Is it also straight forward tuning the power commander for the right map on the computer
@MondayCheese
4 жыл бұрын
Can I ask if there was anything different you did? I followed the tutorial step by step on my 2020 zx6r abs and it doesnt run with it connected. I removed it and now I have an engine light and the Traction control is disabled..
Man... it just can't be this easy....
@json216
5 жыл бұрын
It's that easy..the lower tops sensor is the black one..under the grey one tho...only tiny detail he didnt point out...but video is awsome